Search results

no... don't add nutes.. more than likely this will slow down the root production... some yellowing is fine... it means your plant is working on pulling the stored energy from it's leaves to put into the roots

you can also make matching V cuts in both the graft host and branch... tape it with graft tape or electrical tape... put a clear bag over the fragile branch (to act as humidity dome) for the first few days-week just like you would a clone... any standard grafting technique should work...

not just possible.... it's been done... you can graft a branch from one mother onto a mother from another strain and have a multi strain mother... or graft male onto female to seed or vice versa

genetic rejection basically... the tree will see the cannabis as a foreign contaminant and will seal it off instead of growing together that's just a generic answer though... i'm no botanist

lower acidity equals higher PH

youre right... a 430 bulb in a 400 ballast will only output at 400... it will work... but it will nto operate at the light output it is rated at @430watts

they look just fine... keep it up

it's probably somewhere close to 85% of natural sunlight... most of the UV is gone... just guessing based on past researching of my own... that's plenty of light though

62500 just sounds... wowish... i mean GE and sylvania have been making light bulbs forever... grow light makers have been trying to push them as hard as possible... and these guys (from aus i think) come out with both a hps that does 62500 @400w and a MH conversion bulb that does 52300 @400w...

don't even worry about stealth and calling an electrician... he doesn't care why you want an outlet put in... tell him to do it and walk away... he'll be glad to accept your money IF he asks.. tell him your wife/gf/mom/boyfriend/you wants a outlet in the closet for some kind of charger and you...

was about to say... this dude really likes to party hard LOL

The short answer is you run a wire from your breaker box to the closet, install a receptacle, and you're done. If you're willing to figure out how your house is wired you might be able to tie into a lightly used circuit and not have to run wire so far or install a dedicated line... but that's...

fan pull air better than they push it as for loud... some are some aren't... plus i don't have one so i can't say...

only advice i have is don't do it

still haven't made it through a full 24 hours yet... but damn close... within minutes of 24 hours of door closed so far my high has been 77 and normally does not go over 74 (found out the timers weren't' sync'd and it was getting hot in the first few minutes.) my low is 65... all in all it...

that he ended up not using... he said due to noise... but his methods were very unsafe... you can do this.. but don't modify the heater the way he did.. unless you enjoy burnign your house down

how should you wire the fan up or evreything up? other than that i'm not sure what you're asking... by that i mean i don't know what kind of fan you're talking about

this is very broad statement considering the multiple different types of "installation" there are which types of "installation" would you be talking about that are toxic to plants? please try to be more specific next time...

take a volt meter and stick it in one hot and then in ground on your 3 prong 240... tell me what it reads the circuitry is there... it's just a matter of safety really

I hope he meant chlorophyll...