024deeweed420
Active Member
Ive been seaching but cant get the answer i need.
I have purchased a hurricanex led controller from steves leds
http://www.stevesleds.com/HurricaneX-LED-Controller_p_237.html
to dim and primarily to use as a timer to switch on and off for day/night cycles. I thought you just connected it directly to the main drivers dimming connection but reading up and asking around i think i need something else inbetween? Im also guessing as my light setup will be six cobs using one of these drivers in simple series connection that i will only need to use one of the 16 channels of the led controller?
This is a description of the driver its a zpe from cutter electronics
PF-P400CC-C140-S-DM
400 watt Hi Voltage Constant Current Led driver, ideal for high Voltage COB series Strings, drives 171 to 286 Volts output, will drive 8 x 36V cobs
I really need a some help , if you can help a total electronics luddite id be much in your debt. Got the tent , got the fans, filters, got the watering/nutes setup and reservoir ( going to do coco grow drain to waste with the nutes delivered via a diaphragm pump on a seconds timer ), got the seeds, just need to get these lights and set em up good.
Steves Leds also sell this and im wondering if i need this in between the controller and the dimming leads of the driver
http://www.stevesleds.com/HurricaneX-10V-PWM-Converter--16-Channel-version_p_335.html
I have purchased a hurricanex led controller from steves leds
http://www.stevesleds.com/HurricaneX-LED-Controller_p_237.html
to dim and primarily to use as a timer to switch on and off for day/night cycles. I thought you just connected it directly to the main drivers dimming connection but reading up and asking around i think i need something else inbetween? Im also guessing as my light setup will be six cobs using one of these drivers in simple series connection that i will only need to use one of the 16 channels of the led controller?
This is a description of the driver its a zpe from cutter electronics
PF-P400CC-C140-S-DM
400 watt Hi Voltage Constant Current Led driver, ideal for high Voltage COB series Strings, drives 171 to 286 Volts output, will drive 8 x 36V cobs
- √ Wide Input Voltage:90~305Vac
- √ High Efficiency up to 94.0%
- √ APFC (Active Power Factor Correction): 0.99 Typical
- √ 0-10V/PWM/Resistor/Time 4 in 1 Dimmable
- √ Programmable Output Current with Constant Wattage Design
- √ Lightning Protection 6kV √ Waterproof: IP67
- √ 100% Full Load Aging Test for 4 Hours @Ta=45℃
- √ Safety Design Compliant to UL8750/IEC61347 √ Thermal Optimized Aluminum Case with Potting
I really need a some help , if you can help a total electronics luddite id be much in your debt. Got the tent , got the fans, filters, got the watering/nutes setup and reservoir ( going to do coco grow drain to waste with the nutes delivered via a diaphragm pump on a seconds timer ), got the seeds, just need to get these lights and set em up good.
Steves Leds also sell this and im wondering if i need this in between the controller and the dimming leads of the driver
http://www.stevesleds.com/HurricaneX-10V-PWM-Converter--16-Channel-version_p_335.html