I searched for the same Samsung strip's but all out of stock for 8weeks. They are cheaper though!
LEDs to supplement my 315wLEC in 4x4
- Thread starter mattiegk
- Start date
InTheValley
Well-Known Member
with 8 luminus cobs, Looking at $630 + alum frame, dimmers, wagos,
8 cobs, 8 active heatsinks, 2x HLG-480H-C2100B,
800 watts available,
8 cobs, 8 active heatsinks, 2x HLG-480H-C2100B,
800 watts available,
Those are 1inch strips , half the voltage too.
Cheers guys think the Samsung strip seems like easiest solution for my needs
gwheels
Well-Known Member
Sorry to ask a question on your thread but....i am going to.
I have a 315 and a QB135 and a 200wat timber 2VL. Would it be better to run the 200 timber and QB 135 than that 315?
I am going to run the 315 and the QB because i will get right to 85 degrees F with both and the vortex on full. And that is as hot as i want to play in the tent. But maybe a chibi with that qb and timber...or another qb 135...
I have a 315 and a QB135 and a 200wat timber 2VL. Would it be better to run the 200 timber and QB 135 than that 315?
I am going to run the 315 and the QB because i will get right to 85 degrees F with both and the vortex on full. And that is as hot as i want to play in the tent. But maybe a chibi with that qb and timber...or another qb 135...
Last edited:
Moflow
Well-Known Member
If it were me I'd stick the lot on. The more lights shining down on the plants the better.Sorry to ask a question on your thread but....i am going to.
I have a 315 and a QB135 and a 200wat timber 2VL. Would it be better to run the 200 timber and QB 135 than that 315?
I am going to run the 315 and the QB because i will get right to 85 with both and the vortex on full. And that is as hot as i want to play in the tent. But maybe a chibi with that qb and timber...or another qb 135...
Just throttle back the leds to suit your temps
nfhiggs
Well-Known Member
0.7 inch actually. They fit nicely on the Heatsink USA .601 profile that costs about ~$1 per foot.
diyled
Well-Known Member
That's a bargain I pay $16 each for mine. Is that at heatsink usa? Do they dril/tap them?
And watt for watt same kind of outputs/spectrum?
Cheers this has been a very helpful thread
Chip Green
Well-Known Member
Yes Heatsink USA, view their website, they do have machining available.....unknown what the costs are.
Im pretty lucky I guess, its a Michigan company, so shipping to my area is very affordable!
nfhiggs
Well-Known Member
They do have machining services. They cut to your desired length for free, but I don't know about drilling and tapping cost. The Samsung strips don't have mounting holes anyway, they have semicircles notches cut in the edges for mounting. I just glue them down with JB Weld epoxy.
diyled
Well-Known Member
Im trying to make the lights upgrade freindly so need the holes. Thermal tape is i nightmare to remove a snapped a strip in 2 and ripped off the trace with the leds still attached trying.
Ill have a look anyway nice one.