Good luck man, that is the reason I feel like most grows get hinky. Moving sucks, luckily I just moved before starting growing again haha. I had a week to find a new place. Ended up living with friend for a couple weeks until I found a location.
I'm going thru the same shit, I hope to have my harvest by sept 10th so I can move when my lease is up, if not I have to stay a month longer o.o
Good luck, July 13 is right around the corner!!! It would really suck if you have to move right in the middle of growing. Worse case scenario you flip the switch on July 13th if you got to be out in 2 months from there.
Peace
BKB
you can add nutrients every other watering just don't over do it its always better to use less them than 2 muchGive me your guys opinions on power feeding. I guess that means give them nutes with every feed, while gradually increasing the doses each week. First week 1/8-1/4, 3 to 4 times. Next week 1/4-1/2, 3 to 4 times, etc.... I need to feed them today and I'm not exactly sure what I want to do. Their last feed was water and the Humboldt Verde (16-1-2) only. My plan today was just straight water, but now I'm leaning towards more nutes.
Thoughts???
If you are seeing pre-flowers it means the girls are letting you know they are ready to go into flowering. You can flip them safely now and you should end up with a good harvest too.
Dubz you will pull close to that if not a little more.. The ones I vegged about 3 weeks .. 18 inches or so all hit about 3 zones already.. and they were not good yielding strains.![]()
Good lookin'. Your babies are going to grow up so fast once that red spectrum is in there. Glad everything seems to be working out if you have to move the grow. Keep us up to date. We worry about our friends ya know.
The lights are good. The unit that's out is my c02/temp/humidity controller. It runs the fan for my hoods, my air scrubber, my dehumidifier and my c02 regulator. Without this thing I'm in trouble. It did the same thing the Sentinel MDT-1 did to me a week ago. The power supply went bad, but why is the question. I am noticing that the outside of the MDT-1 is getting hot, right where the power supply is. I had my second ballast cable running across the top of the Sentinel CHHC-4 so I may have overheated the power supply? The cables from my ballast are warm but not 'hot'. Everything seems to be generating three times as much heat as before. With just the one MH bulb I could keep the temp at 80 to 81 during the day. Now that I have the MH and added the one HPS it won't go lower than 86-87... now when I add the other HPS, I may have a serious heat issue. Or I could attempt to flower them all under one of the HPS, or leave it how it is now with both the HPS and MH. I may try running both HPS just to test out the temp. If I can't control it then I won't have a choice but to use only one HPS. Holy stressed out batman...