Cannaventure 6 LVTK 4x4

dstroy

dstroy

Well-Known Member
whitebb2727 said:
Looking good.

I'm shut down right now but am working on a new grow space. Most likely will be 5x5 with cobs and a bit of t5.
Click to expand...
I haven’t kept up with what’s new at all since I built those fixtures. Been really busy with life, you know how that goes. I did get a little 65w quantum board for my moms but I kept a 2ft t5 for my cloner.

I like the look of rapidled.com heat sinks, cause drilling and tapping all of mine sucked ass. I paid I think $13 each for mine undrilled and theirs are $19 and drilled and tapped for popular shit already. I probably put about half an hour of labor into each, and I like to think that my labor is worth more than $12/hr by a considerable margin. If I had known about them I would have bought those. Who knows there could be a better deal out there, haven’t looked.
 
SSGrower

SSGrower

Well-Known Member
dstroy said:
I haven’t kept up with what’s new at all since I built those fixtures. Been really busy with life, you know how that goes. I did get a little 65w quantum board for my moms but I kept a 2ft t5 for my cloner.

I like the look of rapidled.com heat sinks, cause drilling and tapping all of mine sucked ass. I paid I think $13 each for mine undrilled and theirs are $19 and drilled and tapped for popular shit already. I probably put about half an hour of labor into each, and I like to think that my labor is worth more than $12/hr by a considerable margin. If I had known about them I would have bought those. Who knows there could be a better deal out there, haven’t looked.
Click to expand...
I broke 2 taps, then decided to use thermal epoxy, saves on cost of holders in addition to being easy. I even was able to pop a few off without damaging them.
 
whitebb2727

whitebb2727

Well-Known Member
dstroy said:
I haven’t kept up with what’s new at all since I built those fixtures. Been really busy with life, you know how that goes. I did get a little 65w quantum board for my moms but I kept a 2ft t5 for my cloner.

I like the look of rapidled.com heat sinks, cause drilling and tapping all of mine sucked ass. I paid I think $13 each for mine undrilled and theirs are $19 and drilled and tapped for popular shit already. I probably put about half an hour of labor into each, and I like to think that my labor is worth more than $12/hr by a considerable margin. If I had known about them I would have bought those. Who knows there could be a better deal out there, haven’t looked.
Click to expand...
I have some cobs and will most likely order more. I will also be testing a new cob based light. Really interested in getting my hands on it. Different spectrum on one cob.

I get the busy part. Usually I'm busy spring through fall and then not much of anything during winter. This year has been busy with a number of challenging life events.
 
Buck5050

Buck5050

Well-Known Member
Looks like a whole lot of grab ass going on in a crowded elevator. The swell is definitely in effect and that should slow height grow. Are you going to let it ride as is? Or is there supercropping in the future?
 
dstroy

dstroy

Well-Known Member
Buck5050 said:
Looks like a whole lot of grab ass going on in a crowded elevator. The swell is definitely in effect and that should slow height grow. Are you going to let it ride as is? Or is there supercropping in the future?
Click to expand...
No more supercropping, they haven’t grown up much after week 5 except for the back left
 
You must log in or register to reply here.
Top