Search results

You can run four Far Red Initiator pucks using this 30v-dc-power-supply and three of these dc power splitter cables. This is recommended by Rapid LED. The pucks can run on a voltage greater than 12v.

Low constant current range Medium constant current range High constant current range

@Innob you could run the long strip and two short strips (parallel wiring) on the driver you have, since they all are 19.5 volt strips. Layout the two short strips in one row parallel to the long strip. Keep the third shorty as a spare part.

4 would work nicely at almost 9 watts per strip (1.82 amps/4 boards X 19.5 volts)

You'd need 3 of those Eb gen 2 280mm strips (parallel wired) to safely use that 1.82 amp driver. EB2 max current is 0.7 amps.

I recommend this $15, 133mm passive pin-fin heatsink.

Here's a Fluence dimming module's spec. page. Not enough info to say that resistor dimming is supported.

That dimmer device wont work with your LED driver. This $6 dimmer potentiometer will do the job.

Here's a few post about the eb3 slim strips.

The HLG 550 is now on sale @ $790 USD.

@iShatterBladderz 1. No = Both channels get power via a single power jack. You need a separate 5 volt pwm timer to dim these supplement boards (ie Bluefish ) or use an IOT Sonoff 4 ch relay to turn off the 660nm before the far reds ( a closed relay =0% PWM and open relay =100%PWM). 2. One...

I imagine the temperature/LED talk had something to to with Vapor Pressure Deficit.

The LDD-H data sheet says voltage input is limited to 46 vdc for the 1200ma and 1500ma mean well ldd dc-dc buck drivers.

Renfro's choice is cheaper too.

A Mean Well APC-25-700 will light one of those emerson effect strips.

Cree XPE2 & 3, CXB3590 Citizen CLU-048 Luminus CXM22 Chilled Logic Puck v3

1 to 10 volt dimmer needed. This might work. Tell us more about the installed driver so grab a screwdriver and your smartphone to take a photo.

more like 2 x $139 Amazon QB 132 search results

Turn this potentiometer to change brightness. Set it with a drop of nail polish to lock in your brightness level.

You had me worried that I'd given out bad driver advice. Glad all strips are lit.