Search results

I am using dutch masters now, but it is too early to tell. I am having ph issues, but I dont think it has anything to do with the nutes. The guy at the local hydro shop swore by them. Could just be cause they are the most expensive though

I am using dutch masters 2 part nutes, about 370ppm, my water to start was 70ppm. I am not using any supplements at all. I noticed on their website they actually figure three of their supplements in into their calculator: Add.27, Silica, and Zone. Like I said my plants have been in the...

OK, so you are saying that adding ph down, probably about 3-4 teaspoons a day to lower the ph to 5.5-6.0 is not unusual. I am sure that it depends on my water but is it normal to have to do this for several days? I mean I am about to be on day four and it does not seem to be rising any slower...

Before I put a fan on my pump, and ran it through a mini fridge, and turned the fans on for my light, the water temp was like 80. It was that high for about 3 days. there was like a brown maybe slightly green film on the inside of my aeroflo. That is why I changed and flushed my res. Is it...

The past 2 mornings when I first checked them they were 6.9-7.5.

I just went and checked on my babies and the ph was 6.9, i added 1 1/2 teaspoons of dry ph down. while i was there in a matter of about 10 min, the ph had dropped to 5.8 and didnt change for prob 5 min. If I go check it in about 2 hours, it will probably be back to 6.8-7

If that is the case, the co2 is waring off, how long do you think it would take for it all to wear off. It has been three days and it keeps going up. I really appreciate your help

Yes I calibrated it 3 days ago. the ph of my tap water is about 6 and it slowly goes up every day

THat is what I have ben trying to keep it at 5.5-6.0

aNy idea why I am having ph problems? just a few minutes ago ph 7.5, water temp 69.5, room temp 72, ppm 360, humidity 49% plants are about 2 weeks and 6 inches. i have 1 1000w mh 24/7 I used the little plugs that came with my propagation kit to sprout seeds then transplanted those to the...

I got those number off the test result pdf of their website. they were in the amount detected column, I do not see calcium in their list.

Since my last post I have kept the fan on the pump and added a fan in the room. My a/t has stayed between 70-72, my water temp has stayed between 69 and 71. THe humidity has stayed about 45-50%. I also flushed my water and took my aeroflo completely apart and cleaned it best I could, fresh...

do you use any of those oher additives?

copper .046ppm, lead 3.5ppb, flouride .86ppm, turbidity .3ntu, chlorine 1.94ppm, haeoacetic acids 33.8ppb, trihalomethanes 58.2ppb

sorry for my ignorance, but what do you mean by a water report?

I am using dutch master 2 part nutes, and I just started. i am having a problem getting ph stable, it keeps rising everyday and stopping about 6.8

I have the same exact system and I have a few questions, what did you put in your pots other than the pebbles? Have you had any problems with ph going up? How often are you having to adjust ph? I am using dutchmaster nutes. 6.8ph, 74 air temp, 71 water temp, 50% humidity, 370 ppm I am only...

Does anyone else use dutch master? I am wondering if anyone is using these other additives they recommend on their website. Add.27, Silica, and Zone. I am having a hard time keeping my Ph below 6.8, everytime I add it goes down temporarily and then goes back up. I just flushed my res and my...

I have a aeroflow2 60 and I am having a problem with water temp and of course pH. My room temp over the last four days has ranged from 78 to 82, humidity is about 35% and my water temp was staying around 80. I used a small refrigerator and ran 50ft of 1/2 plastic coils in the fridge and pumped...

what is your water temp?