DIY with Quantum Boards

I'd go with a 240H-C2100 for 2 boards. I've gone from running 4 boards on a 320H-C2800 driver to 2 on the 240Hafter having a driver fail and leaving me with no light.....


Frank Nitty said:
Found it for three but not for two... Hlg 320h-c1750a for three 288s,but i just looked
at the driver for 2 on a kit and got it that way... Hlg 240h...
Click to expand...
 
l
maxlev said:
I have many that would work from Burgeon to Snap-on, but the one that fits perfect is size 1 phillips from this set
Click to expand...
. I stripped my dim screw to my hlg135xw quantum board is this screw your mention the size for the dimmer? Also can you replace the screw with a new one to prevent it from happening again or just try not to damage it more?
 
Dear ol" Thankful Grower! said:
l
. I stripped my dim screw to my hlg135xw quantum board is this screw your mention the size for the dimmer? Also can you replace the screw with a new one to prevent it from happening again or just try not to damage it more?
Click to expand...

Yeah, size #1 phillips for dimmer screw
If I were to munt the plastic screw head, I reckon I would add a tiny amount of good glue to the screwdriver tip, hope it sets & never remove it.
Got to be easier than stripping the driver & replacing the butchered component
 
maxlev said:
Yeah, size #1 phillips for dimmer screw
If I were to munt the plastic screw head, I reckon I would add a tiny amount of good glue to the screwdriver tip, hope it sets & never remove it.
Got to be easier than stripping the driver & replacing the butchered component
Click to expand...
Solid thanks I’ll pick one up tomarrow hopefully not stripped bad enough
 
hillbill said:
Does that light up the whole side of the hill open like that? Watts?
Click to expand...
I'm running the HLG-240H-C2100A drivers so each board is ~ 114 watts at the wall. I've also been experimenting with some different options above the plant. Had 2 QB288's for a while. Switched to a 600 HPS for a while (I needed more heat). Just replaced that with a 315W CMH.

Lots of watts - I certainly won't be winning any grams per watt contests but that was not my goal either.
 
What is your goal? seems like an excessive amount of light for one plant.


Hot Diggity Sog said:
I'm running the HLG-240H-C2100A drivers so each board is ~ 114 watts at the wall. I've also been experimenting with some different options above the plant. Had 2 QB288's for a while. Switched to a 600 HPS for a while (I needed more heat). Just replaced that with a 315W CMH.

Lots of watts - I certainly won't be winning any grams per watt contests but that was not my goal either.
Click to expand...
 
You must log in or register to reply here.
Back
Top