Sr. Verde's: Concentrate Corner

poplars

Well-Known Member
So who is harvesting / has harvested outdoor that they are planning to use for hash? :) :eyesmoke:

I'd love to see some plants! Or hash pics!

already showed you some ;) have like 7-8 more plants to process so there will be much more hash it will just take me a while to get through it all :D
 

Matt Rize

Hashmaster
Please watch this if you dab BHO. And please help spread this around the forums.

[video=youtube;FkaWim2L_1I]http://www.youtube.com/watch?v=FkaWim2L_1I[/video]
 

irieie

Well-Known Member
so are cannabis oleoresins or concretes the waxes that you are speaking of? and if so are they a byproduct from the butane or an extract from the plant material? and if the latter than why would they not also be found in ice water hash?
 

cannabineer

Ursus marijanus
so are cannabis oleotesins or concretes the waxes that you are speaking of? and if so are they a byproduct from the butane or an extract from the plant material? and if the latter than why would they not also be found in ice water hash?
They are plant waxes, and they are depleted in bubble hash. Leaf extracts are very waxy. From bud, much less so, esp. fastidiously groomed bud. cn
 

irieie

Well-Known Member
Good stuff... Thanks for the share..
I find It more constructive to show people the way rather than just saying "your all fucking idiots and your doing it wrong, and only I know the special secrets to keep from doing it wrong but i am not gonna tell you because I am so cool, neieeeeeeaaaaaaaaaaaa!"
 

Aldini

Member
Has anyone considered using super-hydrophobic spray on the inside of the extraction tube to increase the yield?

Super-hydrophobic spray - http://www.youtube.com/watch?v=7is6r6zXFDc

My guess is that the spray would keep the butane gas flowing through the tube with more speed and pressure possibly getting more thc from the contents. BUT I have no clue what this stuff is made of and am a little worried that the chemicals could react with the butane. What do you guys think?
 

oilmkr420

Active Member
a closer look @ minimum requirements to perform sub/supercritical fluid extract.
gauge
needle valve
2,100 psi rating vessel
check valve415.jpgThis set up allows co-solvents to be introduced w solid co2 through a one way check valve preventing any back flow. The vessel holds the matrix and dry ice, butane can flow into the vessel being bled until liquid starts flowing out the other end. Then shut off the needle valve, and hook up to a mother tank of co2 through the check valve, but don't bleed the tank. Use the pressure and add the heat using the gauge as a max psi rating is observed.
 

poplars

Well-Known Member
fresh runs in the last week and a half:

sour kush diesel pheno 73 (diesel 1, last of the trim. there will be a small bud run of each strain however.)

tahoe OG kush 73 (there was more but I only put the highest grade dabbable in the jars ;) )

90:

blackberrykush 73 micron on top 90 on bottom:
 
Top