question on cloning.

Brick Top

New Member
Im not saying that I dont appreciate you giving your advice and it is a useful tip. I didnt even know that was possible and I will try it but in a later garden. is there anything i can do to maximize THC level out of these reggie plants?

Here is a portion of an article about trichomes, THC percentages and UV lighting.
A researcher conducted a controlled experiment in a greenhouse. He lit a group of high potency plants similarly except with the addition of UVB light to some groups. He found that the percentage of THC increased in a direct ratio with the increase in UVB light. This research confirms the adage that high altitude plants are more potent than those grown at low altitudes.

If you look at old-world land races of cannabis, plants that have become adapted to the climate and latitude, the ratio of THC to CBD starts at 100 : 1 at the equator. At the 30th parallel (The Hindu-Kush Valley) the plants have a ratio of 50 : 50. At the 45th parallel the ratio is near 1 : 100. This corresponds roughly with the amount of UVB light received at these latitudes. There is much more UVB at the equator than the 45th parallel.

How can you get more UVB light to your plants? Certainly it's true that MH lamps emit more UVB light than HPS lamps. Still the amount that MH lamps emit is small. In fact, many manufacturers use UVB shielding glass to filter out most of the UVB that's produced. The UVB light the plant receives from an MH lamp does increase the plant's potency slightly at the cost of yield, but there are better ways to introduce UVB light into the grow room. They include reptile lights, which emit about 10% UVB, and tanning lamps.

Here is a short piece about a research study that was done about increasing levels of THC by giving extended periods of darkness before harvest.

"The Stichting Institute of Medical marijuana (SIMM), the first company to sell marijuana through the pharmacies of Holland, has been investigating the medical possibilities of cannabis, together with TNO laboratories and the University of Leiden. One of their discoveries has been that to keep the ripe plants in the dark before harvesting could increase their potency.

SIMM’s growers separated a crop of mature plants, harvested half of them and kept the other half in absolute darkness for 72 hours before cutting and drying. Analysis of the resulting dried buds showed that some varieties had seen an increase of THC of up to 30%, while CBD and CBN remained the same."

I hope that between the two it is at least a half decent beginning in your quest for increased levels of THC.
 

skunkushybrid01

Well-Known Member
I finally figured it out. You are confusing my having given information on what CAN be done for me having said it would be the best thing or a good thing when I never said that. I only offered an option that would work and nothing more. If you remember where I said I have never done it while in flower? That is because I have always cloned early, I have never taken a clone after a plant has gone into flower and while it can be done I would never suggest it to anyone. Again, I only offered another option and nothing more.
I find it astounding that you've never taken a cutting late into flower. I'm not confusing anything... i'm saying that your post is irrelevant to the (indirect) question in the quote. Flowering plants are more difficult to clone sometimes, and sometimes they're not. i do it all the time because i'm lazy... seed plants are showing, i should really clone them... fuck it, i'll do it tomorrow. tomorrow turns into next week and before i know it i'm re-veg'ing clones again. so i know they pretty much just root at the same time. The hard part is the re-veg'.



Reading comprehension ... it comes in rather handy my lad.
I have plenty of that, which is also why i don't need to cut n paste other people's words.
 
Top