Need Help Troubleshooting My Light ASAP

Krytend

Krytend

Well-Known Member
Also i appreciate the help
CobKits said:
food for thought. apart from down time, and the time to solder, 5 holders is cheaper than that one cob that burned up
Click to expand...
Do you sell holders that fit the rapidled led heatsinks? The whole reason i went with tape was i couldn't find holders that fit 1212s and the 140mm pin heat sinks.
 
CobKits

CobKits

Well-Known Member
i dont know how they are drilled, surprised thats something they couldnt advise on.. 35mm spacing is the most common spacing for cob holders. if you have 2 holes 35mm apart with no holes in between them thats all you need
 
Krytend

Krytend

Well-Known Member
CobKits said:
i dont know how they are drilled, surprised thats something they couldnt advise on.. 35mm spacing is the most common spacing for cob holders. if you have 2 holes 35mm apart with no holes in between them thats all you need
Click to expand...
Ok I'll take a look and measure the holes. I got a soildering iron and rewired my light with just 4 cobs and i guess my driver is shot too. And yes Airwalker i i wired it correct + to - and match polarity at the driver. I'll have to buy some holders and a new chip from you payday.
 
Airwalker16

Airwalker16

Well-Known Member
Krytend said:
Ok I'll take a look and measure the holes. I got a soildering iron and rewired my light with just 4 cobs and i guess my driver is shot too. And yes Airwalker i i wired it correct + to - and match polarity at the driver. I'll have to buy some holders and a new chip from you payday.
Click to expand...
Driver should be able to power 4 no problem.
 
You must log in or register to reply here.
Top