Need Help Troubleshooting My Light ASAP

[CobKits]

food for thought. apart from down time, and the time to solder, 5 holders is cheaper than that one cob that burned up

 

[Krytend]

Also i appreciate the help

food for thought. apart from down time, and the time to solder, 5 holders is cheaper than that one cob that burned up

Do you sell holders that fit the rapidled led heatsinks? The whole reason i went with tape was i couldn't find holders that fit 1212s and the 140mm pin heat sinks.

 

[CobKits]

i dont know how they are drilled, surprised thats something they couldnt advise on.. 35mm spacing is the most common spacing for cob holders. if you have 2 holes 35mm apart with no holes in between them thats all you need

 

[Krytend]

i dont know how they are drilled, surprised thats something they couldnt advise on.. 35mm spacing is the most common spacing for cob holders. if you have 2 holes 35mm apart with no holes in between them thats all you need

Ok I'll take a look and measure the holes. I got a soildering iron and rewired my light with just 4 cobs and i guess my driver is shot too. And yes Airwalker i i wired it correct + to - and match polarity at the driver. I'll have to buy some holders and a new chip from you payday.

 

[Airwalker16]

Ok I'll take a look and measure the holes. I got a soildering iron and rewired my light with just 4 cobs and i guess my driver is shot too. And yes Airwalker i i wired it correct + to - and match polarity at the driver. I'll have to buy some holders and a new chip from you payday.

Driver should be able to power 4 no problem.

 

[Krytend]

Driver should be able to power 4 no problem.

Yeah i tried 3 cobs also beacuse the driver is 89-179V. It alwasy did run hot like 180f with the temp gun