Is it dead?

It had been slowly getting yellow. I flushed it with gh to try and get my runoff neutral.

It did this after that. Idk. It isn’t drinking much.

Medium is Berger bm7 with lots of pearlite added. Gh 3 part ph at 6

Flushed because the runoff was very acidic.

Wow, thanks guys.

So I surrounded it with acorns and garden gnomes, seems to be greening up nicely.

Did I post in the wrong section or something?

When you say acidic, what exactly?

When you flushed did you feed straight after?

Why were you measuring the run off ph in the first place?
Was there an issue that caused you to do that?

Would like to see more pics of the whole plant, but a little closer. At the very least, cut out the worst of the dead leaves and make sure your humidity is low with some draft in there. I’d probably harvest based on the pics. How old are the plants?

It's one plant It's been a few months anyway, should be close. I posted a pic 2 weeks ago or so and one person responded with a few weeks left so...

The environment is good. I have a humidifier in there and some ac infinity controllers to keep it around 1 -1.2 vpd.

It was slowly starting to turn yellow, so I flushed it. For lack of any better idea's, that made it look all yellow, so wrong move there.
I did flush to a normal ph range then feed normally at the end.
How acidic? red on the gh test drops. I flushed it with 5 gal of ro water which is high ph. The first gallon I used florakleen in.

I have used floakleen before but not with these results.

I'll post some pics in a bit.

Link to post about when to harvest. There 3 pics in this.

Pics from today.

i would chop and wet trim. those dead leaves can cause mold, at this point they have stopped growing, and will continue to crisp up so save what you can.

As far as maturity how far along is this plant? If you were judging trichomes is it even close?
My plan was to freeze the flower wet and make bho, which I have never done before.
I figured it was the most foolproof thing as far as drying and curing and all that.

i would say you will get some decent product if you use if for concentrates, but id make sure to clean up the dead leaves before processing. A lot of hash makers cur earlier than later for lighter color

Cleaned it up and froze it.
Set some decent looking stuff aside to cure. Got about a qt jar of that and two 1 gal bags stuffed full.

I tried a bit in a mighty vape. Can't say that it was all that bad being wet. Kind of slight steam effect to it but still had terps and def had some punch.
I liked the terps I tasted tasted quit a lot, but I am curious to see if it comes out stronger after processing.

I froze a loaded tube to make bho with, should be able to try that today as well if it off gasses nice.. Haven't done this bit before so wish me luck.