larrypizzimp93
Well-Known Member
I bought the growers choice controller and it has port a and port b that each port can control up to 100 lights but there’s only 1 plug on the controller
How to hook up multiple lights to growers choice controller?
- Thread starter larrypizzimp93
- Start date
LeastExpectedGrower
Well-Known Member
I just looked at the actual lights and they have two ports...so that would be one for an in and one for an out. Then you just daisychain the fixtures.
larrypizzimp93
Well-Known Member
How do I daisy chain? The lights say port a and port b on them so I’m assuming I can only plug all my lights into one port to control that port?
LeastExpectedGrower
Well-Known Member
Did you read the manual? Because I feel like you didn't read the manual.
Because:
Is what the manual says. Line out from the controller into the 'A' port on the light. Line out from the 'B' port on the light into your next light's 'A' port. Repeat for however many lights. I'd pretty much guarantee the A and B ports are parallel wired as suspected.
StonedGimp
Active Member
No to hijack the thread but how do you setup boost mode for the roi-720 on the controller?