Ez squeeze rosin press

What temps are you getting with your plates?

I found 185 is best for keif with out buddering up.

DemonTrich said:

I found 185 is best for keif with out buddering up.

Click to expand...

have you tried lower temps?

Ok, I wasnt sure if you were pressing or trying to get rosin.
What temps you run for rosin?

185 was the best for rosin.

I did a neat little hack & added a knob to the jack pressure release valve so I won't have to use the slotted bar to release the jack pressure....

Yeah, the bar sucks for that. Where did you source the knob from?

DemonTrich said:

Pressed about 1/4 of my keif.

Click to expand...

Maybe I'm doing it wrong, but my rosin doesnt look anything like the pic you posted. Im pulling extracts from the bubble hash and getting a thick honey like rosin, then I chuck the pressed puck of hash in the trash.
My method is: put pressed puck of hash into a coffee filter and wrap it up, then put that puck into parchment paper. Press the puck between the heated plates and collect the rosin concentrates from the parchment paper. It looks like the stuff in your pic is just warmed up keif smushed more than actual extract from the keif?
It took about 8-9g of bubble hash to get this 2g of rosin from it.

25iu baggies
5g each baggie. 7g caused blow outs.
Dry ice extracted keif

Clean looking blonde. I've never run dry ice....thinking I might give it a try.

I did mix the budder and waxy stuff together. I won't do that again. Temps deffinately play a part in the end result.

I run about 220*f, but I dont have the heavy gear you guys have so I rely on the higher temps more.
The stuff you just showed is how mine looks after pressing.
Where you get the 25 mic bags from? Those seem pretty neat and tidy vs coffee filters lol

DemonTrich said:

Yeah, the bar sucks for that. Where did you source the knob from?

Click to expand...

I actually lifted it from an old electric lawn mower out in the garage. It was a plastic knob that had a steel nut snapped inside. I just popped the nut out & hacksawed slits for the little bar across the release valve. It fit better than I imagined..

Amazon
I think the price is cheaper if going direct. The micron size is different for what your pressing. Next time I'll bubble bag all my trim and run that. See how that comes out. Then I'll just press trim after that. See which tek is easier and best results.