Don’t tease me but I need help
- Thread starter budman410
- Start date
whytewidow
Well-Known Member
Wow that's crazy. It's like they sent them before finished. They dont even have cutters printed stamp.
https://www.cutter.com.au/product/ssk-1560-730_660/?attribute_pa_led-wavelength=mixed-wavelength This is what I got. I think I did 4 deep red 8 red
I’m going to check the rest and see but looks like I’m screwed
Cana-bliss
Active Member
Do you plan on running these with your other lights during the full lights on period?
rkymtnman
Well-Known Member
wow, those are much, much cheaper than rapid. i need to look into what shpping would be. thanks for that link.
crimsonecho
Well-Known Member
I see on the link you have given that only buying option is solderless. So i really think thats the wrong order. There must be a mistake there.
I’m going to try and get better pics tomorrow and go over my order. Yes they are suppose to be soderless I thought the black tiny lever on the side was for it to attach and detach. Anyone order these before for a comparison picture
JavaCo
Well-Known Member
Missing 1/2 of the quick release looks like to me. I would show cutter the pics and see what they say. Hooking it up backwards wont fry it just wont light up. Hooking LEDs up backwards turns them into light sensors rather then light emitters. I would guess the solder-less quick release by the logo is +.
welight
Well-Known Member
Apologies, this set of boards did not come with Cathode/Anode markings. Please note the connector under the Solskin logo is Anode(+)
The board is fitted with the new Wago 2065 solderless, extremely low profile and reflective and with higher rating, 9A to 600v
Cheers
Mark
The board is fitted with the new Wago 2065 solderless, extremely low profile and reflective and with higher rating, 9A to 600v
Cheers
Mark
Airwalker16
Well-Known Member
No.. you're so far from "screwed". Simple multimeter would be able to tell you what's what in seconds.
Thank you mark, that makes it very simple. I’ll try them out todayApologies, this set of boards did not come with Cathode/Anode markings. Please note the connector under the Solskin logo is Anode(+)
The board is fitted with the new Wago 2065 solderless, extremely low profile and reflective and with higher rating, 9A to 600v
Cheers
Mark
Airwalker16
Well-Known Member
So.... Without the tool, your unable to release wires from the connectors?
Or is there some way to do it without?
Looks like it just makes it easier, I pushed the lever with my finger and it released the wire.
The strip stats say 27v, I brought a 60 30a Hlg it lit up then flickered out. Think I need to up to 36v?. Tried my other driver and it worked perfectly very nice lights
Last edited:
Yea before the lights come on and during lights on flowering time. I’ve read stretch generally happens early in flower so got the first couple weeks I’m not gonna run them. Some I’m putting over my moms for intentional stretch for clones.
Airwalker16
Well-Known Member
Run em from first day of flip.
Any suggestions about a driver obviously this 60 isn’t going to work. Wanted to run them soft