Don’t tease me but I need help

JavaCo · May 11, 2019

budman410 said:
Any suggestions about a driver obviously this 60 isn’t going to work. Wanted to run them soft

That driver will run two of those strips in parallel going to take them to the maximum 1000 mA drive current though. Running three on that driver will run them close to 700 mA. If you just have one strip I would use a driver like A APC-25-700 that will run it @ 700 mA https://www.jameco.com/z/APC-25-700...le-Output-11-36VDC-700mA-25-Watt_2164009.html

welight · May 11, 2019

Airwalker16 said:
So.... Without the tool, your unable to release wires from the connectors?
Or is there some way to do it without?

no it is quite simple with a sharp tool to push down on the small ' bikers pedal' to release the wire or use it to insert wire
Cheers
Mark

budman410 · May 11, 2019

JavaCo said:
That driver will run two of those strips in parallel going to take them to the maximum 1000 mA drive current though. Running three on that driver will run them close to 700 mA. If you just have one strip I would use a driver like A APC-25-700 that will run it @ 700 mA https://www.jameco.com/z/APC-25-700...le-Output-11-36VDC-700mA-25-Watt_2164009.html

Pretty satisfied with the lights overall I def prefer this lever over the usual push wago. Easier and appear less likely to put too much pressure on it

Don’t tease me but I need help

JavaCo

Well-Known Member

welight

Well-Known Member

budman410

Well-Known Member