Bulletproof Glass Collection

i use plastic foodsaver containers... vacuumed
Category_Header_canisters.jpg

the 3 big round jars in the middle
 
Nice oil rig! Drop a TI nail in there and get $300 for it :) I have problems getting bubbles that big that dont break from thinness. Any suggestions?
 
I start with a big ass tube and ball it up like I would an r-ball. Just make are after you get it molten spin it out of the flame so it spreads the heat evenly. Then blow. If you blow it right out of the flame it looks like a kidney bean. Hope that helps. Actually I smoked out of already. Next one will be h20. Didn't have the right fittings for a downstem. Wanted to get it in the kiln. Have to go in through the top of my kiln with gloves and sleeves everytime I took it out or put it in. Sux
 
If you got the muscles go 50 unless you wanna condense the glass alot. I use my bong tubing.I pull a point and use the biggest flame u got. Heavy wall 50mil is what I used at least.
 
WoW! Could have swore i was subscribed to this thread. Guess not to its like 5 pages ahead of where i left off. had to catch up subscribed now hehe.
Awesome work on everything so far bro. Hows the new kiln working out ;)
 
This is a basic reclaim jar on a oil dome that I have seen around a couple of times.
reclaim jar.JPG
With the normal oil rigz we find the oil that drips off the nail ends up running into the bubbler and the water and it's LOST!:cry:
DSC02769.jpgDSC02767.jpg
(This is our rig after 36hrs of use...were not dirty...just smoke a lot of oil!)
With a reclaim jar in the mix you can catch the run off and melt it AGAIN!:lol:
 
Done... made another table, dome, and a heady diamond Sherlock ... gotta wait till morning to post it... can't wait to use it.. thanks for the idea. I already know ima like it..
 
Diamond Sherlock
2011-09-17_12-06-00_482.jpg

2011-09-17_12-09-59_670.jpg

dome. Just made the connector and jar.not the Old dome n bong
2011-09-17_08-33-47_558.jpg

spoon
2011-09-16_13-19-03_37.jpg

..not bad for a coulple hours ..
 
Back
Top