Search results

Side note: Wyze makes some super cheap cameras, you have to load a custom RTSP firmware (direct from the manufacturer).

Nice start! I got lazy... I use Sonoff smart plugs flashed to a custom firmware so they work with HA... then just control the power and set the humidifier/dehumidifier into always on mode. Started doing some research into smart flood sensors awhile back- I was thinking either the Shelly flood...

Exactly. Even seeds that were asexually produced can/will have some level of variation. The only way way to keep it identical is by cloning.

Agreed, not getting much smell off the Sherbet yet compared to my kosher kush but they are the exact age/roughly same size and the buds on the Sherbet are way more advanced....already picked out my pheno to keep if they smoke as good ;-)

2.5 weeks into flower and good so far!

Well they were alive for awhile, 3/4 of them reverted back to veg. Unfortunately I finished that round of flowering and decided I didn't really want to keep the genetics anyways so I tossed one in my compost bin and gave two away (I was super short on space).

About two weeks into flower... same setup, Sherbet on left and Kosher Kush on the right. My HLG 600 RSPEC is up to full power now.

I need new seeds to test my completely revamped setup with upgraded HLG lights (and to make my next grow journal with)!!!!

About a week into the stretch and looking nice and even- the two on the left are the Sherbet (two on the right are my Kosher Kush)...

Nice looking plants! Do you get multiple uses out of that chicken wire? Seems like a PITA to get the plants out of at harvest

Said screw it and flipped to flower 8 weeks, 1 day from seed. I looked over my photos of the last two weeks growth and if the stretch is too much more than that was I'm screwed as is space wise. It's the first winter I've grown in this house but the temps aren't too bad (this room has the...

I'm debating on pulling the trigger and flipping to flower soon. They're rocking thick AF trunks and starting to fill in my mesh. At most one-two more weeks of veg (they're already at 8 weeks).

...And decided some of the beets needed to be on my plate for dinner

Well I meant to switch out the mesh for greenhouse fabric before the first real snow hit.... I was a little late :D:D The only garden still going is my square foot raised bed. Fortunately it's just cabbage/beets/turnips/kale for the most part. A few heads of broccoli left that might get...

I've got my tent running pretty high CFM so I don't notice the smell yet. I will say one of my Sherbet plants has a thicker stem than my plants normally do at harvest already! Woody AF, thicker than my thumb.

Just a week later and that one in the back left of my tent is exploding again. It's totally dominating the 10 gallon pot now. Nice and bushy with 8 colas (mainline)

USA 323 THANKS!

Ran out of room for more pictures on the last post. Here you can see the mainline/training. Still need to add a third emitter per 10 gallon pot just to make sure it's getting evenly watered but I ran out of 1/8 inch transfer barbs setting up my drip for this run.

6 weeks from seed, just topped the final time (8 colas now)... I'm training pretty aggressively with landscape staples. The two on the left are Sherbet (the other two are Kosher Kush from GoG).... it's always sad to cut off that much healthy looking growth. Stems are getting woody.

Re: "water purification" - skip anything fancy. You just need to remove chloramine and chlorine... trace nutrients in the water shouldn't be harmful. You'll also need to balance pH. So a good organic pH up/down product, meter, and then for removing the chemicals dose your water with either...