Search results

Thanks. Using that technique, what PPFD will I be shooting for during early veg, late veg, early bloom, etc…?

sorry, but I couldn’t find it in the faq I know how to take a picture on my phone, I even know how to look at it on my phone, but I don’t know how to post pictures here, so you guys can see them. How’s it done?

Update- My seedings are looking very happy and my qb288v2 is only using 26 watts! It’s a single board qb288v2 4000k with an hlg-120h-54a driver. The driver has been turned down all the way since I put it on the seedlings about a week ago. Today I got a kill-a-Watt and it says my light was using...

So, dim it to 50 percent, hang it 18 above plants and lower it an inch a day until I get to 12 inches above plants or I see bleaching? Sound good?

Lower it slowly… How far? Then what?

I have sing I have a single 288v2 QB 135w max rated.

I have a fresh new quantum board that I want to put over my seedlings in a 2x2 cabinet. It’s a single 288v2 with an “a” type driver. My plants are a week old and they’re currently about two inches below a 105w cfl. What height and power do you recommend when I swap the lights?

Idk. The guy at the hydro shop said they looked tight, so I went for it.

https://www.amazon.com/Activated-Control-Lighting-Parties-Birthday/dp/B06WVB8P3B/ref=mp_s_a_1_8?keywords=led+disco+light+remote&qid=1550626928&s=gateway&sr=8-8

Just got these hella bright LED Disco grow lights! They don’t say how many watts they push, but it’s a lot! I bet one would flower the shot out of a 4x4. I don’t have Flux charts, but it’s a super heady spectrum. They’ve got a built in light mover, so they cover more area without hot spots. You...

I’m taking baby steps. Still reading a lot of diy led, but I ordered one 288v2 4000k w/ slate 1 from hlg and an hlg-120h-54a from Digikey. Soon, I’ll have a good reading light!

I’m in WA, USA

Sorry to interrupt, but what is “SWIM”?

Can you direct me to the diy section that you mentioned? Thanks

Qb288v2 single board driver question: The kit from HLG for a single qb288v2 comes with an hlg-120h-54a. Would a hlg-150h-54a be considered an upgrade from the 120, or should I stick with what hlg chose for their kit?

What about burning a little bit of propane, like a small stove or heater? Burning propane would create heat, co2, and humidity. Has anyone tried it?

1212ham, thanks for the great links!

You hit on something that concerns me. I will be growing in a tent, in a cold shop. The shop temp is 40-70 F depending on the season. I really like the idea of using LED’s, but I need heat from somewhere and it would be silly to save energy on lights if it means using more energy to run a...

Do you have part number for the f series strips you’re using?

I can’t find much. It’s 324 lm301b at 3500k