I've only spent 7/8 days getting through a load of various trim and bud I'd been gathering crop after crop, by the time I was finished + what I'd picked up here and there this was my final method, it might help...
Without a bucket put all the bags inside each then i put carabiner clips through the eyes to keep them as one then put them aside, I then mixed a batch of buds/trim and filtered it into one bucket from the work bag then siphoned off the top 3/4 of water after it settles, I repeated this numerous times catching everything from the work bag into one 10ltr bucket then I filtered everything in one go, after the initial filtering I dipped them again into a bucket of fresh water to suspend the resin again and ensure the finer particles got through to the appropriate levels.
I use a syringe to gather the resin into one area of the bag rather than it spread around the mesh, once gathered I sit the mesh on tissue paper to draw the water out of the resin its very effective after 4/5 mins you can pick it off in one firm lump.
To dry it I put it on a silicone surface and broke it down roughly with a small spatula then gave it some time and went over it again after a few times it falls to dust when you touch it, at this point I put it in a oven bag and broke it all down to a powder with my fingertips.
I used the same oven bag to hand press it with a some heat.