Light height

[Falnseraph]

Hello, I have a couple of questions, or two. I have a 6 bar 600w led. Right now, I have them on low, about 25% about 6 inch above canopy. Are they too low in power and should I raise the height a bit? Also, is it normal for one strain to really take off while others lag behind? still in solo cups.

 

[BobThe420Builder]

No clue what the light is so hard to help

I never run mine less than 75%. Raise them, turn them up. Higher up = more spread and coverage and deeper penetration

 

[Homegrown Hero]

My plants really responded to 100% power, light about 30” from the canopy.

 

[Southernontariogrower]

1 ft 50% slowly raise power, let them tell you, ive got plants 4 inches from light praying for more. Already maxed. Mine is 8 bar same wattage.

 

[Southernontariogrower]

Hello, I have a couple of questions, or two. I have a 6 bar 600w led. Right now, I have them on low, about 25% about 6 inch above canopy. Are they too low in power and should I raise the height a bit? Also, is it normal for one strain to really take off while others lag behind? still in solo cups.

What rating is light? Mine 1482 umol, so about 1080 usable umol.

 

[Falnseraph]

If this helps, heres the ppfd chart.

edit: Link to light

 

[Falnseraph]

What rating is light? Mine 1482 umol, so about 1080 usable umol.

1500

 

[BobThe420Builder]

What's the light

Pics and info

 

[Falnseraph]

What's the light

Pics and info

I edited one of my posts with a link. Pls excuse my bad posting etiquette .

 

[BobThe420Builder]

Crank it up
Raise it up

Utilize the light

It's NOT a T5 light bulb

 

[Falnseraph]

Crank it up
Raise it up

Utilize the light

It's NOT a T5 light bulb

Lol, done and done. Wonder how much time was lost with the lights set as they were.

Almost had a heart attack! After adjusting the lights, the wench didn't lock and the front of the lights swooped down, knocking the cups over!! All us good though! Hahaha

 

[BobThe420Builder]

I hate it when wenches don't listen