Hi everyone. Been reading lots, and learning.
I’m at day 18 for autos, and day 11 for photos. Some are going well but some not so. Hope you can help. I have not used nutrients yet.
What I would like to know in first week how much water should be given / soaking the media until runoff before transplant etc.. Then from that point how much water to feed.
5 issues I have noticed;
Yellow / bleached leaves on the autos
Brown spots / brown lines
Brown around the edges
Curling up
Stunted growth
See photos attached (autos from day 7 to 11) - some bleaching and brown spots (what are the causes for each) ?
Most reading points to overwatering, heat / light stress, wind/fan burn
- Lights were run 24 hours for first 2 weeks then cut back to 18/6 schedule
- Temps did get to 28 C / 82F for few days but now controlled at 26 C / 78F
- Humidity around 60-70%
- 70/30 coco/perlite mix (with about 10% vermiculite)
- 630watt LED at 25-30% light and 27” above top of canopy (was at 22”)
- Fans were pointed directly at the plants but are now for the last 5 days are blowing overhead instead
- Pots are all fabric pots that were just sat in saucers but now are sat on mesh metal pot stands within the saucer to help with drainage.
- Run off was around 250-300ppm when rinsing the media
- pH for them all is now around 5.8 to 6.1
More info on Autos
- Autos were in paper cups with drain holes that were then transplanted to 5 Gal (I read not to transplant shock and plant in the pots you aim to grow in from the start)
- They were under a 400watt LED and 18” away but after reading about bleaching causes I moved them to other LED light where there was more space. (will the bleaching go away or just not occur from this point on?)
- pH was on average on the low end 5.4 to 5.8 and each day I was trying to mist higher pH water to bring it up.
I have also attached pics of the photos which shows brown spots, curling - ideas?
I’m at day 18 for autos, and day 11 for photos. Some are going well but some not so. Hope you can help. I have not used nutrients yet.
What I would like to know in first week how much water should be given / soaking the media until runoff before transplant etc.. Then from that point how much water to feed.
5 issues I have noticed;
Yellow / bleached leaves on the autos
Brown spots / brown lines
Brown around the edges
Curling up
Stunted growth
See photos attached (autos from day 7 to 11) - some bleaching and brown spots (what are the causes for each) ?
Most reading points to overwatering, heat / light stress, wind/fan burn
- Lights were run 24 hours for first 2 weeks then cut back to 18/6 schedule
- Temps did get to 28 C / 82F for few days but now controlled at 26 C / 78F
- Humidity around 60-70%
- 70/30 coco/perlite mix (with about 10% vermiculite)
- 630watt LED at 25-30% light and 27” above top of canopy (was at 22”)
- Fans were pointed directly at the plants but are now for the last 5 days are blowing overhead instead
- Pots are all fabric pots that were just sat in saucers but now are sat on mesh metal pot stands within the saucer to help with drainage.
- Run off was around 250-300ppm when rinsing the media
- pH for them all is now around 5.8 to 6.1
More info on Autos
- Autos were in paper cups with drain holes that were then transplanted to 5 Gal (I read not to transplant shock and plant in the pots you aim to grow in from the start)
- They were under a 400watt LED and 18” away but after reading about bleaching causes I moved them to other LED light where there was more space. (will the bleaching go away or just not occur from this point on?)
- pH was on average on the low end 5.4 to 5.8 and each day I was trying to mist higher pH water to bring it up.
I have also attached pics of the photos which shows brown spots, curling - ideas?
Attachments
-
347.7 KB Views: 55
-
224.1 KB Views: 59
-
240.6 KB Views: 65
-
219.7 KB Views: 58
Last edited: