Aussie Growers Thread

Yea thought it would be.
Will take a few runs to get dialled in I’d say.
And good idea jzs.
My best harvests have been a mixture of mh and hps. Plus will save a bit on initial set up costs going that way.

What size do you want to go? 3x3 and 4x4 are standard for a manageable size res under. The X-Trays and Duralastic are deeper, although there’s a good generic 3x3 low rise at only 100mm deep.
A 4x4 is best with a 200L res and a 3x3 is half or less of that in res size, depending on how deep you flood.

I did 3x3’s for years and now 4x4. 3x3’s easier to manage. 6 inch sq per plant is about the tightest pack you want to go with no veg. I just gave a very light feed to clones under the T5’s about 2-3 days before plant out to get new growth going.

You’ve got experience with DWC so that’ll serve you well with F&D, like res maintenance, light proofing root zone etc..
 
Last edited:
Where u get em. Nubco is like 9 bucks.
Dunno man iv only looked on ebay.
Was lookin at the 60g packs

Edit: cant remember where i was reading it but was a list of recommended pack size for what amount of bud. 60g was round the pound of bud mark from memory
 
Bout 40 to 50 percent humidity
With ac on.
When its off gets upto 70 percent.
But im not exhausting room atm
As i have that in my drying room.

Cheers for advice.
70% is probably closer to where you should be jzs but I start bringing my humidity down a bit to be on the safe side early to mid flower.
Just try not to fluctuate humidity too much, humidity increases quite a bit when lights are off.
 
What size do you want to go? 3x3 and 4x4 are standard for a manageable size res under. The X-Trays and Duralastic are deeper, although there’s a good generic 3x3 low rise at only 100mm deep.
A 4x4 is best with a 200L res and a 3x3 is half or less of that in res size, depending on how deep you flood.

I did 3x3’s for years and now 4x4. 3x3’s easier to manage. 6 inch sq per plant is about the tightest pack you want to go with no veg. I just gave a very light feed to clones under the T5’s about 2-3 days before plant out to get new growth going.

You’ve got experience with DWC so that’ll serve you well with F&D, like res maintenance, light proofing root zone etc..
Was thinking 4x4 ozy.
So 200 litre res....
I’m thinking from what I know and from your guys advice that I’ll setup for 3 x 4x4 tables, (perpetually harvesting a table every 3 weeks) 3 x 200 litre res’s a shit load of clay balls and net pots.
I already have 3 big air pumps, one for each res. And I’ll order a spare air pump.
What size submersible pump would be best for a 4x4 ozy?
And yes I’ve learnt the hard way with air leaks, high water temps, not keeping res, air stones, line etc sterile enough :roll:
and another bonus to this is I will only have 3 res’s to worry about and not 12 buckets lol.
 
There there if u want them
I typed in boveda then filtered it to Aust only and they were one of only 3 in aust
Should grab them before their gone.
Cant say iv used them an i dont plan on hangin onto the bud long once dry but if it means better product ill grab them
 
Back
Top