so its 3kW total?Each plant had 4 x 225W COB LED fixtures. It was borderline excessive lighting lol
how is the heat?
how much btu ac you use?
so its 3kW total?Each plant had 4 x 225W COB LED fixtures. It was borderline excessive lighting lol
There were 6 plants in the system, the LED lights ran down the middle. 5400W total. There was NO heat, because the lights were water cooled. A chiller removed heat from the water.so its 3kW total?
how is the heat?
how much btu ac you use?
The metal top you have, make one for the bottom too. The hole can be smaller. hang a few CM above bottom fan, air can go around. 3 notches cut out for plant bases. In the centre of each hole place one LED or a cluster firing at the other side.
It will be nice and bright like the inside of a UFO.
Bro, very much !!! I need a little time to get myself into this.))))5400W total..
That was for 6 plants, spread over 144 sq ft, or 13.38 sq m. Also it was a lot of light, borderline too much.Bro, very much !!! I need a little time to get myself into this.))))
That was for 6 plants, spread over 144 sq ft, or 13.38 sq m. Also it was a lot of light, borderline too much.
The design was meant to keep the watts used equal to the CMH lighting I replaced.
One could use as little as half the watts I did with good results.
This is not true.No current LED can beat 315CMH for light output. LED's can match them at a lower temperature though.
This case my wife is engaged in)))),That's going to be a lot of trimming!
I try to keep the level)))Well done!
Thank you, bro, I also hope so))I expect you will have a wonderful yield.
GR8 job my friend!
Every time I open my tent that is what I want to see.
GR
Hello, bro!Very impressive grow Sedan.
I myself feel that your defoliation of the fan leaves is what gives you all those bud sites.I do basically the same thing but with just 1 600 watt hps bulb.Been stripping fan leaves for years and it is obvious to me that the more light one allows to hit any spot a bud can form the more one gets back at harvest time.
How long do you veg your plants again?
I spent 10 cents, and 10 minutes of time !!!
The pipe cost $0.00, part of scrap for my biz, time factor was minimum as nothing is glued just cut and put together. If I bought the pipe it would have cost about $3.00 to make two of these units, but it did take longer than 10 minutes. Stubborn bastard that I am.Today I have a need to change the location of the lamps a little. I thought for a while, and decided to do so. In my opinion, this is the easiest and cheapest way to fix the lamp.
I turn to you, Bro: how much time and money did you spend on this design ?? !!
View attachment 3969608
Thank you, Bro! Join, the most interesting is ahead! ))sit collecting dust, such waste. )