Will this reveg need a clone?
- Thread starter 4bt4life
- Start date
hotrodharley
Well-Known Member
Container is far too small. Needs to be fed. Badly.
CaliRootz88
Well-Known Member
The Causes of Cannabis Leaves Curling Down and How to Remedy Them
Curling down of cannabis leaves is mainly caused by nitrogen toxicity, overwatering, bad soil, extreme temperatures, genetics, and windburn. In this guide, we will look at these causes and remedies for curly marijuana leaves to ensure your plants grow healthy and produce a high yield.
101growlights.com
A few possible answers. I’m sure you can figure out at least one of these reasons contributing.
cannabiscrusader
Well-Known Member
Put that haggard lady in a bigger pot. It should show signs of revegging in 3 weeks or so. First few leaves are usually single blades, it will grow out of it and back to normal after one or two nodes.
waterproof808
Well-Known Member
I’m not really sure what you are asking but you should definitely take clones off of that plant instead of reflowering it in the same pot.
4bt4life
Member
This plant has already been harvested my mother died I take clones from so I need this to make new growth for a clone
hotrodharley
Well-Known Member
Personally I’d trim it big time and transplant. Reveg is faster from trimmed than the way it is. Break up the root mass when you transplant. Also it doesn’t need high PPFD. You’re trying to get it to veg. Lower light levels.
Jamie0715
Well-Known Member
i was gonna say trim her up alotabit cut her root ball in half maybe(use your judgement), replant and run 24hrs till you see some new growth, from there do you!!!