i did what u guys said with the bakeing soda and dish soap but how many time do i spray it? and the leaves that have the white powder on it are very week and frail thay snap if there bent . iv had this white powder befor but not as bad as this time its worse and some of the leaves stems are red whats with that someone told me there sucker leaves and get rid of them is this so
White Powder NEED HELP!!
- Thread starter YaManN
- Start date
weezer
Well-Known Member
ithink it is powdery mildew
what you do depends on how much money you want to spendand size of op
get some powered sulfer and blow it on your plant it cost about $5
or you can get a sulfer burner for about 200$
i have this problem for the first time went to hydro store and they told me about the sulfer.put a little on paper and blow it on to plant..
it worked great..
you may have to repeat spots you missed
what you do depends on how much money you want to spendand size of op
get some powered sulfer and blow it on your plant it cost about $5
or you can get a sulfer burner for about 200$
i have this problem for the first time went to hydro store and they told me about the sulfer.put a little on paper and blow it on to plant..
it worked great..
you may have to repeat spots you missed
Lord Dangly Bits
Well-Known Member
It sounds like the area you live in has a lot of that powdery mildew. I do not have it where I live, I am lucky. But I used to live in an area that has it. I had to make sure to change my clothes and wear slippers in my grow room. And even this did not make it 100% sure i would not get it. What these people are saying about sulphur is true, But I also always clipped off any leafs that had any on them.
Best of Luck. That is some nasty stuff. Even the sulphur is nasty.
Best of Luck. That is some nasty stuff. Even the sulphur is nasty.
misshestermoffitt
New Member
You are lucky to be in an area that is free of that crap.
It can be caused by to high of humidity / getting the leaves wet when watering.
Lord Dangly Bits
Well-Known Member
It is also in nature, in places with high Humidity. This is why if you live in an area that has it heavy, you should change clothes and shoes, so you do not transport the spores into your grow area. NO SPORES.. NO Powdery Mildew. But the crap also floats in the air. So a good filtration system on your house and grow area would be nice also, but costly.
misshestermoffitt
New Member
I have one outdoor plant that used to get it really bad every year so I've been really careful not to get the leaves wet at all when I water this year and so far so good on it.......
Lord Dangly Bits
Well-Known Member
I Miss the RAIN!!!!!!!!!!
Introduction:
Powdery mildew is a common fungal disease that can seriously damage indoor and outdoor crops. Powdery mildew can rapidly infect crops in both vegetative and flowering stages, coating leaves, stems and buds in fungus.
Powdery mildew typically thrives in cool, damp, shaded and poorly ventilated areas. Airborne spores brought into the grow room land on leaf surfaces and will germinate given favorable conditions. High night humidity levels often trigger the growth of mildew spores. Powdery mildew can attack indoor crops year round.
Powdery mildew is almost impossible to stop in late flowering, so early detection and control is essential. Perpetual harvest, dense scrog/sog systems, and damp basement grows are particularly vulnerable to powdery mildew. Note: strains vary in their susceptibility.
This FAQ focuses on indoor prevention and treatment options. Please read Bongaloids Powdery Mildew FAQ for more information.
Identification, Symptoms and damage:
Early signs of powdery mildew include white powder/fuzzy patches on leaves (usually low in the canopy) and a fuzzy white coating on lower stems. Note: powdery mildew can be wiped off the leaves for a quick visual check.
(photo provided by turtle power) (photo provided by just one blunt)
These fuzzy mycelium patches produce airborne spores that rapidly attack adjacent plants; mildew will eventually coat leaves and entire plants, reducing photosynthesis, plant vigor and bud quality.
Plants on the edge of a garden, in corners and under stress are attacked first; infection usually starts in the lower canopy where conditions are optimal. As infection progresses, mildew will spread to the top of the plants and finally attack the buds.
Infected buds may appear normal; but are internally dusted with white powder (which cannot be removed by drying), and have a stale, musty/moldy smell when dry. Smoking or trimming infected buds can cause sickness and lung infections, and is not recommended. Infected leaves should be discarded. Lower buds are the most susceptible.
Powdery mildew is difficult to 100% eradicate; control requires prevention, early detection, and pro-active measures.
Preventive gardening:
Preventative gardening techniques can be effective in defending against powdery mildew.
Maintain healthy plants. Stressed plants are often attacked first, so it is important to monitor and remove unhealthy plants.
Detection. Inspect corners, edge and lower portions of the garden frequently. Remove infected leaves, or move infected plants out of the main garden.
Dont water plants at night. Reduce or stop watering before the lights have gone out to help evaporate and reduce room humidity (thnx dutchmaster).
Reduce plant density. Spread plants apart to improve air circulation. Dont place plants directly against walls or into corners, typically areas of poor air circulation. Pull plants 6-1 away from walls or reflective surfaces, and blow air to these areas.
Pruning. Remove the lowest leaves as the plants mature and prune the bottom 1/3 of the plant during veg to increase airflow inside the lower canopy. Remove all unnecessary growth. Put an oscillating fan down low to blow through this pruned area.
Foliar feeding. Foliar feeding can sometimes cause excessive nighttime humidity levels. Discontinue if mildew appears.
Harvest early if mildew is a problem.
Environmental control:
Improving growroom conditions is an excellent way to passively prevent and minimize damage by powdery mildew.
Monitor humidity levels. A quality humidity gauge should be used to monitor day and night r.h levels. Avoid prolonged high humidity levels: 50-60% r.h is ideal. Humidity must be kept below 70% during the night; levels over 80% will guarantee infection within 48 hrs.
Ventilation. Constant air movement inhibits mildew, and lowers humidity. Use oscillating fans on all sides of a garden to circulate the air. Ventilate air out of the grow room periodically during the night cycle to reduce humidity from irrigation and transpiration.
Note: Once mildew is established, oscillating fans may actually spread spores throughout the garden. Stop fans, treat infected areas, and then resume airflow.
Heat night air. Warm air holds more moisture than colder air. Heat helps dry the air and lower humidity during the night cycle. Heat the room at night and exhaust the room periodically to remove this warm/moist air.
Dehumidifier.Very effective in preventing mildew from spreading. Set controls for 40-60% and let run during night cycle.
Hepa filter. Filter the intake with a Hepa filter to eliminate spores from entering room. Inspect and change filter frequently.
Ionizer / Ozone generators. Leak some output to kill airborne pathogens and spores.
* Sulphur burner. These devices vaporize (not burn) elemental sulphur, coat the room with a fine film of sulphur, inhibiting PM spores from germinating. Also inhibits insects to some degree.
Run for 12 hours initially (at night, exhaust blower off, circ fans on), then 1-4 hrs/night thereafter. Some discontinue when buds begin to form, other let it run up to the last week. Very effective prevention
https://www.rollitup.org
Powdery mildew is a common fungal disease that can seriously damage indoor and outdoor crops. Powdery mildew can rapidly infect crops in both vegetative and flowering stages, coating leaves, stems and buds in fungus.
Powdery mildew typically thrives in cool, damp, shaded and poorly ventilated areas. Airborne spores brought into the grow room land on leaf surfaces and will germinate given favorable conditions. High night humidity levels often trigger the growth of mildew spores. Powdery mildew can attack indoor crops year round.
Powdery mildew is almost impossible to stop in late flowering, so early detection and control is essential. Perpetual harvest, dense scrog/sog systems, and damp basement grows are particularly vulnerable to powdery mildew. Note: strains vary in their susceptibility.
This FAQ focuses on indoor prevention and treatment options. Please read Bongaloids Powdery Mildew FAQ for more information.
Identification, Symptoms and damage:
Early signs of powdery mildew include white powder/fuzzy patches on leaves (usually low in the canopy) and a fuzzy white coating on lower stems. Note: powdery mildew can be wiped off the leaves for a quick visual check.
(photo provided by turtle power) (photo provided by just one blunt)
These fuzzy mycelium patches produce airborne spores that rapidly attack adjacent plants; mildew will eventually coat leaves and entire plants, reducing photosynthesis, plant vigor and bud quality.
Plants on the edge of a garden, in corners and under stress are attacked first; infection usually starts in the lower canopy where conditions are optimal. As infection progresses, mildew will spread to the top of the plants and finally attack the buds.
Infected buds may appear normal; but are internally dusted with white powder (which cannot be removed by drying), and have a stale, musty/moldy smell when dry. Smoking or trimming infected buds can cause sickness and lung infections, and is not recommended. Infected leaves should be discarded. Lower buds are the most susceptible.
Powdery mildew is difficult to 100% eradicate; control requires prevention, early detection, and pro-active measures.
Preventive gardening:
Preventative gardening techniques can be effective in defending against powdery mildew.
Maintain healthy plants. Stressed plants are often attacked first, so it is important to monitor and remove unhealthy plants.
Detection. Inspect corners, edge and lower portions of the garden frequently. Remove infected leaves, or move infected plants out of the main garden.
Dont water plants at night. Reduce or stop watering before the lights have gone out to help evaporate and reduce room humidity (thnx dutchmaster).
Reduce plant density. Spread plants apart to improve air circulation. Dont place plants directly against walls or into corners, typically areas of poor air circulation. Pull plants 6-1 away from walls or reflective surfaces, and blow air to these areas.
Pruning. Remove the lowest leaves as the plants mature and prune the bottom 1/3 of the plant during veg to increase airflow inside the lower canopy. Remove all unnecessary growth. Put an oscillating fan down low to blow through this pruned area.
Foliar feeding. Foliar feeding can sometimes cause excessive nighttime humidity levels. Discontinue if mildew appears.
Harvest early if mildew is a problem.
Environmental control:
Improving growroom conditions is an excellent way to passively prevent and minimize damage by powdery mildew.
Monitor humidity levels. A quality humidity gauge should be used to monitor day and night r.h levels. Avoid prolonged high humidity levels: 50-60% r.h is ideal. Humidity must be kept below 70% during the night; levels over 80% will guarantee infection within 48 hrs.
Ventilation. Constant air movement inhibits mildew, and lowers humidity. Use oscillating fans on all sides of a garden to circulate the air. Ventilate air out of the grow room periodically during the night cycle to reduce humidity from irrigation and transpiration.
Note: Once mildew is established, oscillating fans may actually spread spores throughout the garden. Stop fans, treat infected areas, and then resume airflow.
Heat night air. Warm air holds more moisture than colder air. Heat helps dry the air and lower humidity during the night cycle. Heat the room at night and exhaust the room periodically to remove this warm/moist air.
Dehumidifier.Very effective in preventing mildew from spreading. Set controls for 40-60% and let run during night cycle.
Hepa filter. Filter the intake with a Hepa filter to eliminate spores from entering room. Inspect and change filter frequently.
Ionizer / Ozone generators. Leak some output to kill airborne pathogens and spores.
* Sulphur burner. These devices vaporize (not burn) elemental sulphur, coat the room with a fine film of sulphur, inhibiting PM spores from germinating. Also inhibits insects to some degree.
Run for 12 hours initially (at night, exhaust blower off, circ fans on), then 1-4 hrs/night thereafter. Some discontinue when buds begin to form, other let it run up to the last week. Very effective prevention
https://www.rollitup.org
misshestermoffitt
New Member
that's a pretty shitty thing to do to someone.