turbo klone 48 HELP!!!

took clones 2 days ago i leave my sprayer on 24/7 ph is 6.0-6.5. temp is 70-73 degrees F. using cutting edge solutions in my res 4 gal res. 3 stage nuets. but cutting edge had a feed chart for clones before and after root so which one do i use here are the measurements
BEFORE ROOT 2.5ml/gal Micro: Bloom 5ml/gal
After ROOT 5ml/gal Micro: Bloom5ml/gal: Grow 10ml/gal

I personally don;t use nutes when I'm cloning anymore. I just pre-soak in a mild rooting solution. Too much nitrogen slows down the rooting process. But, If you must I would go for less so I'd opt for the 2.5ml micro and 5ml. bloom. JMO

I run my sprayers 1 min on and 5 mins off. I use a little Clonex in the water. Temps are close to yours. Never check the ph. Always 100% success. After they root I move them to solo cups of FFOF. From that point they get the same nutes I feed my big girls. I figure they are already use to that strength cause that's what they were getting before I cut them off.. I use Jacks 20 10 20. 1 tsp per gallon. I usually mix 3 gallons at a time to water all my girls..


Good Luck !!

i use a little Great White to stop the slime and run my water temps around 78-80. I use a little Protekt also. I dont PH and I use tap water.
I runn 11 minutes off 30seconds on. Or i sometimes just leave it with no timer.

i run 24/7 cuase someone i know and ive seen there setup same as mine running everything 24/7 except the light cycle. Thanks for the help and info or guide i guess i should say knowing this makes me feel more at ease. Now its time to enjoy some Lucky Charms