Sr. Verde's: Concentrate Corner
- Thread starter Sr. Verde
- Start date
Sr. Verde
Well-Known Member
this is NOT me.
[video=youtube;qVAmqjPiamo]http://www.youtube.com/watch?v=qVAmqjPiamo&feature=player_embedded[/video]
Whaat? Off a spoon... that was a huge dab, it just kept going
nice share
Sr. Verde
Well-Known Member
Fresh oil hanging in the air
I thought it was a cool shot so
From this series of photos > https://www.rollitup.org/galleries/403230-sr-verdes-rollitup-glass-index-45.html#post6564971
researchkitty
Well-Known Member
The nail stays in place by way of either fins on the titanium nails or dots on the glass nails that makes it "rest" on top of the male joint that the dome slides over......
dankshizzle
Glassblowing Moderator
My new travel dome I made so I don't have to take a bong to parties. Its the shizz
y
dankshizzle
Glassblowing Moderator
Damn.. you guys quieted down this weekend..
How do you guys clean ur dome? I was thinking of making a drip pan so to say that I can put my dome on and heating in my toaster oven so I can reclaim the oil that stuck to the sides.
How do you guys clean ur dome? I was thinking of making a drip pan so to say that I can put my dome on and heating in my toaster oven so I can reclaim the oil that stuck to the sides.
Sr. Verde
Well-Known Member
I turn my sink on to run hot hot water... then I let my water rinse all the excess oil away..
Then I clean with ISO and salt
dankshizzle
Glassblowing Moderator
I was looking fir a way to keep the execs oil. Had a lot if newbs smearing it inside the dome.
ENDLSCYCLE
Well-Known Member
Asked the same question once and someone recommended putting my pieces I want washed into a ziplock....adding a couple ounces of Iso. Alch. and swishing it around....then dumping the golden liquid onto a plate to let the Iso. evaporate.......never tried it.....but it sounds good!!!
budlover13
King Tut
i always kinda wondered about reclaiming the oil. Never had any real success though.
budlover13
King Tut
Did a similar thing. Was fairly potent but harsh as hell.
oakley1984
Well-Known Member
lol you want a way? ill tell you the most basic simple possible way, scrape it out!
http://www.ebay.ca/itm/D00071-Clay-Ceramics-Clean-up-Sculpting-Tool-OOAK-/190442951476?pt=LH_DefaultDomain_0&hash=item2c5748d334
buy yourself one of these lil 5$ marvels
http://www.ebay.ca/itm/D00071-Clay-Ceramics-Clean-up-Sculpting-Tool-OOAK-/190442951476?pt=LH_DefaultDomain_0&hash=item2c5748d334
buy yourself one of these lil 5$ marvels
ENDLSCYCLE
Well-Known Member
The Iso part is what turned me off.
dankshizzle
Glassblowing Moderator
Seemed like heating it back into a small pyrex pan worked. I was just holding ut with long tweazers and torching it. Letting it drip then scraping again
researchkitty
Well-Known Member
Get an oil adapter like the clear one you see right in the front..... see how it has a drip catch right there? Seems like about 15-20% of the oil I smoke ends up at the bottom and I just heat it a little and let it drip out into a dish.
budlover13
King Tut
i just always wondered what the makeup of that residual oil was. Would be kinda cool to run some samples through a lab.
