Scrog frame

davillains

Well-Known Member
made a little scrog frame today with 16mm pvc electrical tubes and 20mm corners & holders. I attached tube holders on the corners (see pic) which makes the frame sit rather tightly without the need for vertical tubes/support ..as I've seen on most similar designs. My tent is a Garden High Pro however and the frame measures 16mm apparently so it's a perfect match.IMG_2882.JPG
 

Attachments

  • IMG_2878.JPG
    IMG_2878.JPG
    3.3 MB · Views: 52
  • IMG_2879.JPG
    IMG_2879.JPG
    4.4 MB · Views: 53
Thanks man. It's pretty tight actually. It needs a little force to slide it up and down, if you do one corner at a time moving it a few inches. It was easy to get in the tent but you have to put it in vertical through the door and then snap each corner in place.
 
I like the clip idea! Never liked the screens with legs myself. Mine is hanging since my brain didn't provide me with the same solution as you. Nice.
 
That thing is tight! where did you get the clips.

the clips are pvc electrical conduit pipe holders
rBAAaFW_FZ-AYBSkAADgzOgWkHs456_l0807b.jpg
 
that's clean and professional looking. i usually just zip tie trellis netting to all the poles. not so cool looking but cheap and easy.
 

Attachments

  • IMG_1062.JPG
    IMG_1062.JPG
    230.6 KB · Views: 22
Back
Top