Running out of room
- Thread starter bud420420
- Start date
MissinThe90’sStrains
Well-Known Member
Super crop ! Bend the stalks downwards and tie the ends down, or bend them over sideways and tie them down to give yourself a shorter plant profile. They will adjust and grow “right”. You’ll also get a wider canopy with more exposed bud sites.
Attachments
I'm also a first time grower...thank you I will try that. BTW these are autoflower.
FmSwayze
Well-Known Member
Those are beautiful! This is a good bad situation, @MissinThe90’sStrains is right. However i would be strategic as possible. I would try to offset your pots, and take your bends towards the gap you make. Perhaps something like this. Be sure to crush that stalk good so it doesn't snap, good luck!
Attachments
Thanks for the diagram, much appreciated!
coreywebster
Well-Known Member
Make sure you Google the correct way to super crop.
Take it slow, if you have to , bend in two places.
You don't want to snap those mains.
But it needs doing.
Try doing it where the 90 degree bent will result in those mains been level with those lower buds.
Looking at the 3rd pic, that's about 50% down from the top
Take it slow, if you have to , bend in two places.
You don't want to snap those mains.
But it needs doing.
Try doing it where the 90 degree bent will result in those mains been level with those lower buds.
Looking at the 3rd pic, that's about 50% down from the top
Much appreciated
weedstoner420
Well-Known Member
If you do supercrop, post some pics after they recover. I feel like a 90-degree bend about 1/2 to 2/3 of the way up on both of those plants would make for a fantastic canopy...
joesoap2013
Well-Known Member
I've tied a bit of string to the top then pulled the string down tied it to the main stem under to branch's to make like an upside down L shape
Or you could nip it
Might be hard like but get your secondaries branches to catch up
A net as well I'd an option
Or you could nip it
Might be hard like but get your secondaries branches to catch up
A net as well I'd an option
joesoap2013
Well-Known Member
Is your stem plyable as in it wouldnt snap if you bend it