Reflow soldering XP-E and XP-G3 to mcpcbs

Abiqua

Well-Known Member
Hey guys
Just got some LM561C S 6 bins in and looking to build custom boards to suit, what sort of board should I build?
Cheers
Mark
i like this configuration which is 18x pieces and 8 rows

add 620nm or 625nm or 630nm and 660nm with 2700k....call it the "Emerson" :lol:
 

NaturalFarmer

Well-Known Member
based on 3 watts per chip 25 would be around 75 watts, you probably would not want much more
Cheers
Mark
How expensive would it be to make a few prototypes to test with? I assume the most cost is in the retooling???, so I figured I would ask. Im running 35 now per 140mm with no issues and it is running cooler than a 3590 is but it isnt apples to oranges . Between 25 and 35 would be great I think. Could you PM me the bill:)
 

welight

Well-Known Member
How expensive would it be to make a few prototypes to test with? I assume the most cost is in the retooling???, so I figured I would ask. Im running 35 now per 140mm with no issues and it is running cooler than a 3590 is but it isnt apples to oranges . Between 25 and 35 would be great I think. Could you PM me the bill:)
I should have asked what drive current are you running these at? do you want all in series or addressable for different colours, I assume you dont want any kind or secondary optic?
Cheers
Mark
 

welight

Well-Known Member
How expensive would it be to make a few prototypes to test with? I assume the most cost is in the retooling???, so I figured I would ask. Im running 35 now per 140mm with no issues and it is running cooler than a 3590 is but it isnt apples to oranges . Between 25 and 35 would be great I think. Could you PM me the bill:)
sorry should also asked mounting holes, which heatsink do you want to use?
Cheers
Mark
 

waynejohn

Active Member
300x300mm sounds good, suplemented with 660nm strips...would definetely be interested in trying them
 
Top