My Cloner, enought light?

My new bubble cloner, holds 7 cuttings. It was very easy to make, using an 4' air stone and a plastic container, some electrical tape to block the light to the roots was wrapped around the base.A few holes were made in the lid and some old sponge was cut to fit the hole, to support the cuttings. A coat hanger and some cellophane was use for the lid.

I'm going to adjust the P.H. of the water to 6.0 and use Stim-Root #3


(for Hardwood cuttings) as my rooting hormone.

im going to use 1 CFL 23W 6500 as my light on 24/0. do you think this will be enough light?

So I went ahead and sniped 4 branches off my mother, That happens to be a mysterious strain that i have grown from bag seed, that i brought back from Costa Rica. I made sure i made the cuts at 45 degrees, i then split the end using a razor, and peeled about 1 cm of skin, off the end.This is my first time cloning I'm a little concerned with the light schedule, any advice would be great!

how did it go lol