Light Height Recommandations?

I have a 2x4 tent with 2 Mars Hydro TS1000 and was wondering if anyone else.rocls the 2x4 with same lighting or maybe the TSL2000 which is basically the same as me 300 watts of LED. And if so what are height recommendations you use that work well with gocing no stress to your plants?

Seeding: 24"
Veg: 18"-24"
Bloom: 12"-18"

Seeing signs of stress, dim or raise light.

Ok I had them on 100 percent power at 45 inches they had alot of stretch breaking soil, so I lowered to 35". I will adjust and set them around 24" and see what's happens. And you quoting to leave at 100 power and raise if I see any issues

They only look to be about an inch tall or so...
How far away is the light that is being used to flower that thing on the left?

No need to go to full power until flower transition.

Seedling to veg I increase power from 25-75% as they get bigger....but these little ones are getting light from whatever is being used to flower that other one...turning on a 2nd light may be overkill for them at this point.

They are both TS1000 and I raised it both up to about 40 inches at 100 because my seedlings. But I just lowered to 26" both of them at 50 percent power. Should be fine right? The Lemon Skunk on the left I vent main branches to give lower 2 more weeks and it should be done. I hope

So if I have them both connected and at 50 percent basically having one light at 100 power. Shouldn't be bad at 26 inches

When I ran Mars Hydro TSW-2000 I kept them about a foot away from the plants at all times on 100% power. I think 2+ feet is way too far away and is going to result in the seedlings stretching a lot.

p.s I'd avoid direct airflow on your plants, it'll cause them to crisp up like in the picture also looks like your temps might be a bit hot or dry air?

calvin.m16 said:

When I ran Mars Hydro TSW-2000 I kept them about a foot away from the plants at all times on 100% power. I think 2+ feet is way too far away and is going to result in the seedlings stretching a lot.

p.s I'd avoid direct airflow on your plants, it'll cause them to crisp up like in the picture also looks like your temps might be a bit hot or dry air?

Click to expand...

I keep fans running on lowest setting and my Temps stay 80-83 and 65 percent RH

Think my leaves turned like that before I had my second Ts1000 I ran two blurples with the one Ts1000 and it was 414 total watts of LED and heard that's overkill for 2x4. So now I just have 2 TS1000 and only 300 watts

ZuuTeD614 said:

I keep fans running on lowest setting and my Temps stay 80-83 and 65 percent RH

Click to expand...

I would try dropping that humidity a bit. Especially in bloom you don't want to be exceeding 55% RH.

calvin.m16 said:

I would try dropping that humidity a bit. Especially in bloom you don't want to be exceeding 55% RH.

Click to expand...

Follow VPD with my Temps I run around 65 percent veg to harvest never had PM or bud rot. I keep plenty of air circulation!