PatchKid
Well-Known Member
what's up everybody, I switched up my setup quite a bit and fine tuned it over the course of the past few weeks and finally got my girls in their new homes!
I have 4 bubblegum clones that were given to me 3 of them being a couple weeks old and 1 being a little less than a month
I'm growing in an aeroponics setup..... I use a table that floods down into the res.... with an inch of water so the roots are submerged with the same water level constantly and I used PVC pipe and drilled holes in it so that water squirts on the top of the roots. the water level never goes up and never goes down its always at 1 inch. a tiny 6 watt submersible pump is all I need to keep this system going!!!
(I did throw a commercial air pump and an air stone in the res for a little more O2)
I also use a thermo electric chiller that was made at home that keeps my water temp constantly at 67 degrees F for a good amount O2 to be dissolved.
My nutrient setup is the 3 part series (grow, micro, bloom) from Cutting Edge Solutions, with Cal-Mag as an additive, Big Up Powder as my bloom booster, and I also run voodoo juice in my res for some bennies
I have 2 of the plants under a 150 watt HPS, and the other 2 under a 240 watt BlackDog LED. I want to see the results side by side and do a comparison!
Plus that's about 400 true watts and I only have 8 square feet so it's decent coverage. I plan on scrogging my ladies anyways to maximize my light spread. I keep my temps at around 73-78 and my humidity at the moment is around 30%
I'll post updates pretty often
thermostat for the chiller
one and only
nutrient line up
easy access hole to mix up food
I have 4 bubblegum clones that were given to me 3 of them being a couple weeks old and 1 being a little less than a month
I'm growing in an aeroponics setup..... I use a table that floods down into the res.... with an inch of water so the roots are submerged with the same water level constantly and I used PVC pipe and drilled holes in it so that water squirts on the top of the roots. the water level never goes up and never goes down its always at 1 inch. a tiny 6 watt submersible pump is all I need to keep this system going!!!
(I did throw a commercial air pump and an air stone in the res for a little more O2)
I also use a thermo electric chiller that was made at home that keeps my water temp constantly at 67 degrees F for a good amount O2 to be dissolved.
My nutrient setup is the 3 part series (grow, micro, bloom) from Cutting Edge Solutions, with Cal-Mag as an additive, Big Up Powder as my bloom booster, and I also run voodoo juice in my res for some bennies
I have 2 of the plants under a 150 watt HPS, and the other 2 under a 240 watt BlackDog LED. I want to see the results side by side and do a comparison!
Plus that's about 400 true watts and I only have 8 square feet so it's decent coverage. I plan on scrogging my ladies anyways to maximize my light spread. I keep my temps at around 73-78 and my humidity at the moment is around 30%
I'll post updates pretty often
thermostat for the chiller
one and only
nutrient line up
easy access hole to mix up food
i have been looking at the growblu leds on youtube there is so many its so hard to pick
