Help me clone properly

The real key here is having the mother plant healthy,low in N and has been foiler fed with cal mag and fulvic acid a few days prior to cutting.
All these articals you u read dont mention the most important part.Look up* cloning mothers*
 
I made a cheap 3 site bubble cloner from a food container and after the 7 day mark I started to see little nubs. At the 10 day mark this is what I got. I put some recharge in there as well but I seen some slime buildup. I plan on only using tap and a few drops of bleach to keep everything sterile.IMG_1566.JPG
 
ya in my experience the bubble cloner is much easier,no need for domes or hardening off when rooted.
 
I normally just cut in a way to create as much surface area on the cut as possible, dip in rooting gel and place in a wet jiffy pellet. Ive got a seedling tray setup in a box under 2x cfl lights and the seedling tray sits between 20 - 25 degrees celcius. Good success rate and roots pop out of the jiffys in about 14 days.
 
It all works. 45 degrees cut, flat cut, clean or dirty sissors, using ur nail, rooting gel, no gel. Doesn't matter. always 10-14 days . Just make sure ur temps and humidity are where they're suppose to be and ur golden .
 
  • Like
Reactions: ANC
I normally just cut in a way to create as much surface area on the cut as possible, dip in rooting gel and place in a wet jiffy pellet. Ive got a seedling tray setup in a box under 2x cfl lights and the seedling tray sits between 20 - 25 degrees celcius. Good success rate and roots pop out of the jiffys in about 14 days.
Same way I do it. I have a bubble cloner and don't use it anymore.
 
Back
Top