JimmyT
Well-Known Member
Your roots in that couple of pics don't look very healthy, there might be a root rot problem.
Haha, ahhh you're funny. That was good, I needed that, thank you!
Your roots in that couple of pics don't look very healthy, there might be a root rot problem.
hey man can i ask what strain that is im pretty sure im growing the same one, im under the influence its sharks breath?Just topped my plants for the first time....these plants are about 4 weeks into Veg (all from seed).
I clipped the very top of the stem, right above the most recent pair of branches
They went from "super vibrant and stiff" to "super drab" in about three hours...they feel really limp and weak now.
Does anyone know if they're going to recover? Is this normal?
Has anyone done LED's on this setup before?
Quick question If the plants stay in the cloner for 3 weeks and then in veg for 3 weeks followed by flowering for 9 weeks wont the plants in veg be ready to move to flowering before the flowering plants are ready to be harvested?
Just thinking....wouldnt the co2 drop into your house if you vent it to the attic (humidity control). I understand co2 "falls". eh?When the time comes I just pull them up out of the containers and move them into the flower room.
I have 2 - 1000W HPS for a total output of 290,000 lumens. My lights have vented hoods the take the air from one room and vents into the attic. That way my room is totally sealed to keep the CO2 in the room. I use a 440 CFM fan to vent my lights. Lights are run at night to help keep temps down.
I use an A/C unit during the heat of the Summer but don't need it the rest of the year.
I use a complete greenhouse control system with CO2. I keep my CO2 at 1500 PPM during the day cycle.
I keep my humidity below 60% and have a 200 CFM fan that vents into the attic to keep humidity in check.
I'm running 3 separate Aero/NFT systems so I can have 9 weeks flower time and a 3 week perpetual harvest cycle.
I use a cycle timer for the pumps. The timer is set to 1 minute on and 5 minutes off. This allows maximum Oxygen to the roots without letting them dry out.
I made 3 separate Aero/NFT systems using PVC fence posts. The plumbing runs inside and is made from the same 1/2" PVC pipe I use for the cloner. EZ-Clone sprayers between each plant site.
14 plant sites. 396 GPH pump.
The frame is made from 3/4" PVC pipe. 18gal. Rubbermaid container for the reservoir.
Here is my formula for my flower room:
Botanicare Nutrients:
126ml Cal-Mag Plus
150ml Sweet
180ml Liquid Karma
540mlL Pure Bend Pro Bloom
I run 2000 PPM all the way until the flush cycle. Some strains like AK47 can handle over 3000 PPM without burning. Other strains show signs of tip burn at just 1700 PPM. Since I run 10 different strains I set my PPM for a good overall value.
Check out the photos for details on my flower system.
Flushing and harvest next...
Unless you want to get raided by the D.E.A I would not do it because a pound every three weeks will take alot of work.
i hate negative nancy mutha@#$%as like you.. why even SAY that? you think we all have not assessed the risk/rewards of this endevour? im reading this 3 years later but it still pisses me off that comments like yours are not removed from constructive threads like this one.
A summary on Page 75Are there any detailed instructions for the aerocloner in this thread? There is no way i can look through 229 pages to find them