First time grower here!

Ziggs

Member
This is my new homemade grow room!

What do you think of it? Is there something that I'm missing besides a carbon filter?

Just got the co2 set up today. PPM was 840 when first plugged the controller in.

What should I set my low/high point? 1000 low and 1500 high?

Had issues with plants cause of rookie mistake of over watering but now they are coming back strong I believe. The plants are 35 days old as of today.
 

Attachments

Msidragon

Member
Your setup is looking amazing only way I can think of improving it is by putting mylar on the floor aswell for some more bounce light for better side branching
 

Ziggs

Member
Your setup is looking amazing only way I can think of improving it is by putting mylar on the floor aswell for some more bounce light for better side branching
That wouldn't be a bad idea. I still need to transplant from the 2 gal to the 5 gal bucket. And still gotta get the scrog net up. I'm just not sure what hight I should put the net up at? And suggestions?
 

Msidragon

Member
Generally as low as possible is best, so that you can weave the branches through and try fill the holes with as much foliage as you can and some people even use 2 nets but I think that's unnecessary if you do it right with the first net, but I would veg them for about another week before setting up a scrog net just so you have something to weave through
 

Ziggs

Member
So after about a week or so just set the net on top then let it grow in to it? Or should I set it up a bit higher than the canopy?
 

Msidragon

Member
In a week set up the net and take a branch through a hole and under the net again and repeat weekly till you have completely flat canopy of leaves with no holes, this allows all budsites to get light and get maximum amount of main colas I would start flowering when 70 percent of the net is covered the net being as low as possible will help with the stretch people get during flower where the plants grow into the lights and get light burn
 
Top