First grow, comments and diagnoses greatly appreciated!

Goggles

Goggles

Active Member
I've got nine plants in smartpots w/coco on a drain table, started from seed about three weeks ago. I'm drip feeding the plants for fifteen minutes three times a day out of a (soon to be expanded) five-gallon reservoir. I'm using Canna brand nutrients with the schedule tool at http://www.cannagardening.com/growguide. The pH is around 6.0 and daily temps range 72F - 84F. Lighting is from four 3500K COB LEDs about 18" above the plants.

All the plants are growing but none of them appear to be doing really well. If anyone could comment on the pics below it would be greatly appreciated. I've looked at a lot of pics of problem symptoms but I'm having trouble really matching them up with what I see on my plants.

Two Dream Machines. One appears to be okay (?), while the other recently developed dead spots on her leaves:
dreams.png


Close up of the spotted one:
dream2.png


Strawberry Sour Diesel. Leaves are curling under somewhat, but no spots:
strawberry.png


NL5 Haze Mists. Edges are curling upward somewhat, and maybe some dead spots on the tips?
haze.png


Tangerine Dreams. Leaves are curling up a bit and also look a bit yellow in patches.
tangerine.png


Jack Herer and Pakistan Valley. Neither of these started off very well but they're hanging in there.
valley.png


Thanks for taking the time to look these over.
 
Mr.Goodtimes said:
What's your ph? Both of your watering and run off.
Click to expand...

I'm glad you asked that! Last time I checked the pH it was around 6.5 and I added a tiny amount of pH down (like a teaspoon) thinking that it would bump it down maybe to 6.0. I should have checked it then though, because just that little bit of down sent the pH below 5.0! I dumped the reservoir and refilled it with four gallons of water from a distiller and four gallons from tap (fairly hard wellwater). I added 50mL of A and B and 75ml of rhizo which is 'light' concentration according to the Canna docs. I also added a tiny amount of pH down to get the pH to 6.0. I rinsed all the pots with this new mixture. The plants were receiving the bad mix for a total of about 24 hours. Here's hoping I didn't damage the roots too much.

After 24 hours on the fresh mix, the spotty plant is looking spottier, but the other plants are all about the same. Is it possible that the low pH could have caused the spots in a single day? And I wonder why just one plant was affected so much?
 
keep your ph in check, it's your 1 grow, I advice against doing things by feeling, you dont have the experience, not yet, your ph meter is your best friend, use it!
good luck and happy growing :)
 
Well, I made some changes based on all of your suggestions and things are looking up. Here's that spotted Dream Machine five days later:

no_spots.jpg


Lots of new leaves, no more freckles on this girl!

I dumped the reservoir and thoroughly scrubbed it clean. The whole inside was covered with a slippery foul-smelling film, no idea where that came from.
I refilled with water from a distiller, added a light amount of Canna A, B, and Rhizo, a capful of CALiMAGic, and pH down to 6.0. I also started checking and correcting the pH twice a day, using a dropper to add pH down now because the instructions on the back of the bottle call for way too much.

I also noticed that the coco was soggy on some of the plants. I originally built the table planning on flooding, so I just switched the pump over to the flood pipe and now I'm flooding to about 1.5" every four hours and about 0.25" every thirty minutes. This seems to keep the coco wet but not soggy and also keeps the roots coming out the bottom of the smart pots wet.

Every plant is showing healthy new growth, even that sad Sour Diesel I had just about given up on.

Thanks for the advice all, I'm so glad I found this forum.
 
Goggles said:
Well, I made some changes based on all of your suggestions and things are looking up. Here's that spotted Dream Machine five days later:

no_spots.jpg


Lots of new leaves, no more freckles on this girl!

I dumped the reservoir and thoroughly scrubbed it clean. The whole inside was covered with a slippery foul-smelling film, no idea where that came from.
I refilled with water from a distiller, added a light amount of Canna A, B, and Rhizo, a capful of CALiMAGic, and pH down to 6.0. I also started checking and correcting the pH twice a day, using a dropper to add pH down now because the instructions on the back of the bottle call for way too much.

I also noticed that the coco was soggy on some of the plants. I originally built the table planning on flooding, so I just switched the pump over to the flood pipe and now I'm flooding to about 1.5" every four hours and about 0.25" every thirty minutes. This seems to keep the coco wet but not soggy and also keeps the roots coming out the bottom of the smart pots wet.

Every plant is showing healthy new growth, even that sad Sour Diesel I had just about given up on.

Thanks for the advice all, I'm so glad I found this forum.
Click to expand...
Needs nitrogen and you splashed water on it. That's what those spots are from. The water amplified the light and it got a little light bleached.
 
bobtokes said:
how much A/B are you adding per litre of water, if you go by the canna guide you will kill them
Click to expand...
I don't like to disagree with you bob, your a damn good chap when it comes to good advice. But I have used Cannas Coco range for the last 5 years per schedule on their website and never had any issues with killing my plants. I start on light feeding if its a new strain that I don't know well and then pump it up to normal, in some cases I use heavy and in the case of OG Kush I had to go above that. That is A+B, I never go heavy on boost or pk13/14.
It doesn't hurt to play on the safe side and go light and see how they react though.

@Goggles first thought was wtf how much ph down.. a teaspoon.. Use a drop at a time. Its strong stuff. I would be flushing my pots to make sure your ph is back to the correct range because it may take ages to sort its self out with a drip system. Then allowing them time to dry out so you know your roots are breathing. Meaning turn off your drip system and measure the time it takes to dry out. They are small plants in large containers and probably getting a bit too wet.
I think I would be hand watering to let the small ones catch up you can always flip your drips back on when they are back to good health and growing faster.

GL with them
 
coreywebster said:
I don't like to disagree with you bob, your a damn good chap when it comes to good advice. But I have used Cannas Coco range for the last 5 years per schedule on their website and never had any issues with killing my plants. I start on light feeding if its a new strain that I don't know well and then pump it up to normal, in some cases I use heavy and in the case of OG Kush I had to go above that. That is A+B, I never go heavy on boost or pk13/14.
It doesn't hurt to play on the safe side and go light and see how they react though.
Click to expand...
no probs mate, i've never used canna A,B at more than 2ml per litre myself, and with everything else i put in my feed, my E.C never goes much over 2.0 thats including the back ground of 0.5
when i first started using it at canna's recommended doses i got nitrogen toxicity in veg, so now i just supplement with 13/14 in flower 1/4 - 1/2 dose to balance things out.
i know a few people that have had this problem with canna a/b, and thats with hungry strains
but each to his own, lol
 
You must log in or register to reply here.

Similar threads

Y
Questions on first grow. Mutations and possible nutrient or pH issues.
Replies
5
Views
349
yourtreeshugger
Y
J
Drooping Leaves with Brown Spots @ wk 2
Replies
10
Views
896
Treesomewanted77
T
Entusia
What is causing this? Spots on curled down and twisted leaves
2
Replies
21
Views
1K
Entusia
Entusia
R
Does this plant look normal? (first grow)
Replies
1
Views
296
rocketdog1989
R
M
Leaves are hardened and curled down and some brown spots/tips.. PLEASE HELP
2
Replies
32
Views
1K
mmccasland92
M
Back
Top