DIY aeroponic cloner nozzles

I want to build my DIY aeroponics cloner. Do I need to spray the roots with misty/vaporized water or more like a lawn sprinkler spray.
A spray mist cooling set would be ok?

Misting would work. It would also clog easier.

U mean misting would clog easier then thicker sprays?

True but thicker nozzles such as the EZCloner clog too depending on use. All depends on your goals.

The main goal is to produce fast clean clones for the RDWC system.

Simple submersible pump in ice chest using EZClone nozzles drilled into 1/2 inch PVC. Have pump run 24/7 and keep water clean and oxidized. T5 lighting and warm temperature environment. Just one way of many to produce rooted clones.

With the high pressure aerocloner setup, it will effect the morphology of the root structure. You'll likely end up with an abundance of finer root hairs, all shagged out in every direction (including upwards), and more conditioned to absorbing the atomized mist..

However, if you go with low pressure (with a manifold + ez clone misters), or DWC "bubbleponics".. you'll get longer & thicker feeder roots that mostly hang down, and search for the water table sooner. Might be your best bet, considering you'll be plopping them into the RDWC asap?