cuttings problem

I've just got some cuttings two days ago, they were just showing roots through the 1 inch cubes, i ve put them in 4 inch ones soaked the 4 inch in ph adjusted water and put them under flouresent light under a propagator to keep humidity up.

Problem is a couple have wilted the 4 inch cubes were quite wet. so i have squeezed them out a bit and left propagator off for the time being. I took the wilted ones out of the four inch and the roots looked to be dying. Have a lost these ones? I think the cubes were just too wet.]

Any advice, the humidity is 60% in the room is there any need for the propagator?

Thanks

no....just let them dry out.......how are you planing on growing these clones?

Ive got a hydo set up, but in the past have had problems with them wiltiing when i put them straight into the hydro pots as the humidity is too low.

Uhh, I hope they cant get too wet... if so they i need to go raise my cubes out of the water

they are not in water, i dunked the 4 inch half way into water then put the cuttings in, then put a propagator over them but obviously the moisture had no where to go.

cant you fit a humidity over them in the system...the reason i say this is....it's best to plant clones right after they root.....In my opinion......they have the most vigor at this time.......plant the clones in the 2 inch cubes that they are in now, and put them in a low wind/low light/ region of your room. Let the roots get some oxygen. just an idea. good luck.

good idea i just took them back out let them get some air