Colloidal silver feminisation

So I’ve been treating three of my plants with colloidal silver and I’m one week in since flip. I’ve been noticing some Male pre-flowering signs on the branches of my velvet bud that I haven’t been treating with silver, I’ve only sprayed it on one low down branch. I’m treating a fire og and white widow as well, which have shown pistil growth. Any ideas on what I should do? I don’t particularly want too much pollen in my tent as I’m planning on using a lot of the finished buds. I still would like some seeds for posterity. It’s my first time using CS, so I guess I’m not really sure what to expect. Any advice would be much appreciated.

did you ever figure out what was up?

igrowpot87 said:

did you ever figure out what was up?

Click to expand...

I took it out because it was all pollen sacs. I collected some pollen, put it on a few bud sites, and labelled the buds. I’m going to plant the seeds, hoping that it was all female pollen. I’ll see what happens (I sprayed a low branch so the silver ions could have travelled throughout the whole plant). I managed to get fire og to produce a decent amount of female pollen, so I definitely have some fire og crossed with gorilla glue, another fire og plant, Velvet bud, and white widow. So I’m going to plant some of these seeds in a couple of months or so, will probably make a post if they turn out good. Noticed my seed supplier is selling female pollen at €80 for 50mg, so it’s fairly pricey stuff!

Just buy a kit off ebay and make it yourself