Renfro
Well-Known Member
There is a regulator somewhere, if you are using a tank it's there, if using it off a tap on a NG line the regulator is installed there after the shutoff valve and the hose is then run to the generator from the regulator.
Co2 generator lpg to ng conversion?
- Thread starter George2324
- Start date
Mr_Manny_D
Active Member
Welp....I'm in the same boat.
I bought 1 4 burner titan ng burner for flower room#1 and a 4 burner TrolMaster LP generator that I need to convert to ng for flower room #2. Neither have regulators which I need to buy. (Just standard NG regulators from Lowe's??) I'm searching for info on conversion from LP to NG. Are all conversion kits the same? (I haven't started looking yet)
Also was there a final thought on "Tee-ing" off a nat gas line into two lines, one into each room. (Dive of pipe etc). Are the flexible gas lines adequate or are the steal pipes a must? (I'm running LED's)
Thanks.
I bought 1 4 burner titan ng burner for flower room#1 and a 4 burner TrolMaster LP generator that I need to convert to ng for flower room #2. Neither have regulators which I need to buy. (Just standard NG regulators from Lowe's??) I'm searching for info on conversion from LP to NG. Are all conversion kits the same? (I haven't started looking yet)
Also was there a final thought on "Tee-ing" off a nat gas line into two lines, one into each room. (Dive of pipe etc). Are the flexible gas lines adequate or are the steal pipes a must? (I'm running LED's)
Thanks.
Last edited:
thumper60
Well-Known Member
They dont need regulators the Lp tank has one if its set up out side by a gas CO.,Same as NG your meter is the regulator you need to change the jets NG comes in at a lower pressure [need a bigger jet than LP]. If you want it safe an legal run hard pipe with a s/o on each one.