lrg
Active Member
Most closet growers have extensive trouble keeping there basic closet cold.
Ill be trying a fairly reasonable way to get cold air into that closet
trying in it my buddy grow soon hope fully 4 or 5 days
https://www.rollitup.org/cfl-growing/206913-iblaze-dros-cfl-g13-thai-16.html
so you have an A/C vent in almost every bedroom.
There a diagrams of most steps to help
and an ac vent is
where your cold air comes out of if some didnt know lol
MATERIALS:
Cardboard box.
Duck(t) tape
blue tape.(doesnt mess up paint)
hanger an strings, or straps.(if needed).
Air ducting 3"inches wide and X' feet long.
2 CPU Fan
TOOLS:
phillips screw driver
a hammer and nails (if your strapping the duct work) or
screwgun an screws
tin snips (metal cutting scissors)
For the duct work
regular scissors or a utility knife whatever your more comfortable with for cutting the box apart and sizing it
Unscrew the fours screw attached to the corners, and
remove the vent cover.
Cut a piece of card board that matches the vents whole.
Now you must purchase your X' by X' ducting (standards three inches around).
Cut a circle three inches in your card board (or whatever diameter your duct is).
Now properly attach your card board to the ducting, make sure it is air tight I advise duct tape cheap and fairly strong enough if you would like to be classy use reflective tape. haha.
Now its time to make side walls for your cardboard so that it will fit properly into your vent.
It will look like a box with no bottom with a whole in the top.
I would advise using duck tape for making the box that'll fit into the vent
and using blue painters tape holding the edge of the cardboard taping it to the ac vent so that it is not ruining your paints finish,
but still holding your newly equiped vent box.
after proper installation and your box is sittin well in place run the duct to the closet
I ADVISE MORE TAPE.
or
if you dont mind messing upp the walls a little go with hooks and strings and or straps that are proper size.
put the duct roughly in between where the light and the plants meet.
so you now have a cold ac feed into your plants
if you would like you may take 2 computer fans and space them nicely through the duct work pushing air from the air vent through your duct in your plants
Down Side
Obliviously your door will have to be cracked to let in your air duct feed and it will be out in the open for anyone who comes into your room.
Up Side
It can be put up and brought down in no time at all i would guess after you built the actual system itwould take 10 minutes after you assembled it.
and just slap your original vent cover back on and its back to normal ready to be cooled instantly.
The fan might not be necessary i will give a fer sure answer after testing
hahaha this might be way to simple of an idea i justt never thought about it and havent seen anyone discuss it
share your thoughts
Here are a few "Paint" pictures.
to diagram the directions of above
As I said this will be experimented with very soon so stay in tune
I will continue to update my experiment please comment if you have tried this or just an educated opinion.
Attachments
-
8.3 KB Views: 118
-
6.5 KB Views: 106
-
5.6 KB Views: 102
-
13.7 KB Views: 158