Anybody know what deficiency this is or it it nutrient burn?

Retailing

Active Member
Coco
Ppm 600
Week 6 flower
Critical orange punch auto, PH 5.8 - 6.02
GHE flora micro and bloom (Lucas formula) 0.5ml micro per litre, 1.5ml bloom per litre, 1.5ml botanicare cal mag plus per litre
Humidity 55 - 65, temps 22 - 26C

need advice on what to do to correct this issue
 

Attachments

getogrow

Well-Known Member
Gotta see the whole plant to give more info. Your giving more Ca then you are any other element. Thats not balanced enough for me.
 

Retailing

Active Member
Gotta see the whole plant to give more info. Your giving more Ca then you are any other element. Thats not balanced enough for me.
Only 2 - 3 of the leaves have the rust spots, would you say lower the amount of cal mag to 1ml per litre?
 

spek9

Well-Known Member
Gotta see the whole plant to give more info. Your giving more Ca then you are any other element. Thats not balanced enough for me.
The GH Flora is concentrated. The amount OP is providing is actually below manufacturer's recommendation (IIRC, I haven't used it in going on a couple of months now).

If the ratio is off, it's not by much.
 
Last edited:

spek9

Well-Known Member
Only 2 - 3 of the leaves have the rust spots, would you say lower the amount of cal mag to 1ml per litre?
No. Do not lower the amount of Cal-Mag. How old are those plants? How long have you been watering with the nutrient mixture you're currently using?

Are you measuring each Litre out individually? It's best to make a bunch at once, instead of trying to measure such minuscule amounts of each nutrient bottle. At least a gallon at a time.
 

Retailing

Active Member
No. Do not lower the amount of Cal-Mag. How old are those plants? How long have you been watering with the nutrient mixture you're currently using?

Are you measuring each Litre out individually? It's best to make a bunch at once, instead of trying to measure such minuscule amounts of each nutrient bottle. At least a gallon at a time.
I’m mixing in 2Litre bottles, I’m feeding until I get around 20% run off and I’ve been using the same feed since they started flowering, pre flowers started popping out around the 25th of April, the stretch started on the 28th (47 days a go, so I’m at the end of week 6 flower)
 

getogrow

Well-Known Member
your at the very beginning of the issue. Its good to notice but not many can tell by looking at a few leaves.
Im usually the last to say this but it seems you have a lot of N going into the mix too. maybe skip a couple rounds of the micro and use bloom and calmag only for a couple waterings. maybe up the bloom to 2ml for those couple feedings.....
 

Retailing

Active Member
your at the very beginning of the issue. Its good to notice but not many can tell by looking at a few leaves.
Im usually the last to say this but it seems you have a lot of N going into the mix too. maybe skip a couple rounds of the micro and use bloom and calmag only for a couple waterings. maybe up the bloom to 2ml for those couple feedings.....
I’ll give it a go, I’ve fed them already today but I’ll start tomorrow for sure
 

Retailing

Active Member
I forgot to mention that I’m also removing the stagnant water from my drip trays, only a little gets left in the bottoms of them. Is this a good thing to be doing?
 

WintersBones

Well-Known Member
Coco
Ppm 600
Week 6 flower
Critical orange punch auto, PH 5.8 - 6.02
GHE flora micro and bloom (Lucas formula) 0.5ml micro per litre, 1.5ml bloom per litre, 1.5ml botanicare cal mag plus per litre
Humidity 55 - 65, temps 22 - 26C

need advice on what to do to correct this issue
Going out on an limb and going to say maybe too much N. That botanicare is 4-0-0, that might be throwing off your ratios enough. Too much N could affect the K which could affect the Cal. Anyone more learned please correct me.
 

Retailing

Active Member
Going out on an limb and going to say maybe too much N. That botanicare is 4-0-0, that might be throwing off your ratios enough. Too much N could affect the K which could affect the Cal. Anyone more learned please correct me.
My bottle says 2 - 0 - 0
 

spek9

Well-Known Member
Going out on an limb and going to say maybe too much N. That botanicare is 4-0-0, that might be throwing off your ratios enough. Too much N could affect the K which could affect the Cal. Anyone more learned please correct me.
I don't see any signs at all that there's a Nitrogen toxicity situation.

Botanicare Cal-Mag Plus is 2-0-0. This is because the Ca source is Calcium Nitrate, and the Mg source is Magnesium Nitrate (Nitrate contains Nitrogen).
 

WintersBones

Well-Known Member
I don't see any signs at all that there's a Nitrogen toxicity situation.

Botanicare Cal-Mag Plus is 2-0-0. This is because the Ca source is Calcium Nitrate, and the Mg source is Magnesium Nitrate (Nitrate contains Nitrogen).
I thought I was seeing what maybe looked like a touch of clawing but I was thinking of a different CalMag entirely, why I though he was giving a lot of N.
My bottle says 2 - 0 - 0
sorry was thinking of a different brand. my bad
 

getogrow

Well-Known Member
I thought I was seeing what maybe looked like a touch of clawing but I was thinking of a different CalMag entirely, why I though he was giving a lot of N.

sorry was thinking of a different brand. my bad
that flora micro is also 5-0-0 ..... 2-0-0 with cal mag and 0-5-4 with the bloom. I think the ratios are pretty decent but going by the plant itself , she looks a lil too green ..... looks a lil heavy on the N.
it dont look like a "problem" though.
 

PadawanWarrior

Well-Known Member
Ya I'm trying to figure what I had wrong exactly. Did i have it backwards then? Low N, not high, would limit the availability of K which would then limit availability of Cal? Is that how to read the chart? Thanks for the advice.
I think N is antagonistic to K. So high N makes K harder for the plant to access. But you could still have height levels of K that are antagonistic to Ca, which would make Ca harder to access. I don't have it fully figured out, but that's what I'm thinking.
 
Top