Search results

https://www.jacksnutrients.com/

Oh and if you upgrade to the dual or tri fuel carb kit, you never have to worry about bad gas again. Just leave it hooked to a propane tank or even the household natural gas line instead, and it will stay ready to go for years.

Anytime I need to take my generator to some other site, I always bring a 4x4 half sheet of thick plywood along with. Then I lean it up against the gen on the side I'm working from (with the exhaust side pointing away in the opposite direction), and it actually does a pretty good job of blocking...

Depending on the kind of muffler you use (some motorcycle ones are better suited for small gas engines), you could probably expect to knock off anywhere from 15-25% of the sound with the custom exhaust. Doesn't seem like much, but it would make a noticeable difference for sure. Especially to the...

For now I would suggest mixing up a separate bucket of the fkleen solution (10ml per gallon), and manually water it into each of the pots until you get runoff. It does have directions for coco, aka soil-less medium, calling for 5ml.. but I would just mix full strength for hydro application...

I would just mod the carbon filter so you can run it inline with the exhaust ducting, outside the tent. Ductape 2 plastic buckets together at the lids to make a longer cylinder, or find a cheap round trash can or something just a little bigger the filter so it leaves an air gap all around it...

Yes. Looks like a mite infestation.

:wink:

You could still get a transfer switch and setup portable generators to auto start just like the standby types do when the power go's out. $$$.. :eek: Its also possible to mod the exhaust systems and add a muffler, to help quiet it down a bit.

Main difference would probably be the heat exchanger cores. The more expensive name brand one use higher quality grades, like titanium.

https://www.growweedeasy.com/cannabis-plant-problems/broad-mites https://www.growweedeasy.com/cannabis-plant-problems/hemp-russet-mites

Technically it should work. , but the chiller could restrict flow a bit. Even though it has 3/4" inlet\outlet fittings, the internal coil could have smaller channels. inside than that. You would only be using one pump, instead of 2 if you put the chiller on it's own loop. You would definitely...

Here is the best and still the most affordable Y-strainer on the market for RDWC\undercurrent systems with 2" manifolds, IMO.

Aphids

Turtles are pretty rad to have as pets! Way more resilient than fish that have gills. The only real problem as far as setting up a turtleponic system is the inherent risk of salmonella poisoning, so probably not the best idea for food crops. I would have no worries growing ornamentals, or...

Just stuff the filter you have inside a large enough plastic tote or bucket with 2 holes cut out. Tape the outlet flange to the hole from the inside on one end, and run the extra exhaust ducting from the tent into the other hole. DIY inline filter, viola!

https://www.nature.com/articles/d41586-024-02393-7