Search results

if your using pin heat sinks you need to now size I would build it like 4'6"or so 4 trays with angle aluminum then put one at both ends to tie it al together small pieces in the middle section for drivers not sure if you can get 10'aluminum angle or not if can you need 5 put cobs 1' on center...

might need to wait until she done flowering and reveg her to take clones

6 1/2x 6 1/2 room you can get more then 4 plants in there and don't go with cheap led mars light pacific light concept, timber, northern lights and there is more good led companies out there

there big enough now for taking clones then let them veg a few days to recoup before flowing I would what longer then that just to make sure all the clones rooted remember to mark plant with the correct clones from it in case of male you can get rid of it unless you what males around for seeds

water temps makes ph rise to

check ebay or amazon

4x4 mother/clone room 4x6'3" veg room rest flower room take 4'slice out of one end for the 4x4 room. rest goes to veg. in the mother room use the bottom for mothers put a few shelves in for clones with light over them. when plants are big put in flower room not sure on size of rdwc but you...

I think you would be better doing diy in that cost to build a light that would be as good or better then the kind light and a whole lot cheaper

how about put some Christmas light on it people will think it is a tree

the sacs take about 2week give or take to mature and start to open the female buds need about 23-30 day after but in flower room buds need to be started to devolope and get some resin on them and then the pollen can stick to it and that's all about the same time and then you will notice the...

I would forget the one out side for this the ones inside spray branch you want with the silver 2-3 days before flipping then every day until you see male sacs mark your branch do not smoke or use this branch for anything when sacs open up it pollinates the other buds and you will get seeds

filter than fan then exhaust ducting through hole in tent you want you filter at top of tent

I just built a led grow light for my flower room im seeing great results it is a little bigger then my 400 watt but not much light spread out better and chunky nugs with it but it was costly to build it compared to hps/MH

I was running two 400watts and fans bill goes up about 70 dollars a month be carefull on dimming lights I have heard by others that it changes spectrum on you when you turn them down don't know it for fact though if your only going to grow 2-3 plants I would go with the 400 5-7 probably 600 8-10...

if your only going to grow a few plants I would not buy a 1000 watt to much wasted light and heat maybe a 400 or 600 remember you will need to get rid of the extra heat any of them will generate but if you are set on a 1000watt I would grow a hell of lot more then a few plants with the amount of...

I would say its thirsty the lower leaves just look limp a little the top looks limp and starting to swivel up light at 18 inches should be ok

if your room is 5x5 a 1000 watt would work if it is narrow and longer maybe two 400 watts would work better go with hps/mh if you can not afford good leds or your just wasting money on the cheap leds

go with the can66 for your size of room

a friend just got ever thing there except filter,and tube,and tape,and controller for 200 dollars insulated ducting 27 dollars is filter and controller and tape worth the extra money to you

you should be ok your stretching on the 4 foot side though 400 hps 3x3 to3.5x3.5 coverage