update: this girl (i hope) seemed to not be going as fast as it's used to the last week. I had the lights about half an inch to a quarter of an inch above them, periodically checking at night to see if they were getting burnt of which they were not. They were all 2700k lights(4 of them) and i could still manage to touch them after been going for at least 8 hours. I understand that the further lumens have to travel, the more lumens are lost, hence the closer the better or so I thought? Is it possible that being that close, even without burning the leaves (about a pencil width away from some parts) can stunt the plant or maybe it's currently in a different phase of flowering? I changed out one 2700k so now I have three 2700k and one 6500; I placed the 6500k a little more above the smaller nodes that I'm hoping will explode, but don't seem to(you can see in the pic). I'm lsting what seemed to be the main node further and further down to expose the middle part that haven't taken off yet, though other parts of the plant are getting taller than that main node, unfortunately though with only ONE node on it and a lot of stem. I also have a picture as close as my camera can focus right beneath the main node and I'm hoping if anyone can tell me the sex yet. Let me know what ya think, thanks fellas for all your help so far.
View attachment 2570121View attachment 2570122 Btw do you guys think my ocean forest soil and MG bloom booster will be enough nutes for this plant? I've been reading about MG/zinc/iron/etc deficiencies and nute burns. I'm watering about every other day or after two days max, basically just feeling when the pot feels like everyone seems to say. It sucks but I didn't drill in a good drainage system with my pot when I made it and it barely drains...although I never FLUSHED it hard to test it out. Any ideas? I used the oven to heat up a nail and poked holes through the bottom which SEEMED to work well, but I think all it did was partially push up the plastic around the hole, blocking incoming water if you get me. Any ideas? Lastly, should I up the dosage to 3/4 or full strength? I'm doing a little more than half now and there's no nute burn. Should I basically give it as much fert as possible UNTIL i see a burn?
