Ok, so this trimming of the fan leaves that have branches growing above them, what are the advantages/disadvantages to doing this? And, would day 8 of flowering be too late to do this?
Well from my basic understanding:
Advantages to cutting off fan leaves: They dont shade bud sites/branches (main reason why i cut them off). Also i was hoping that by cutting the fan leaves off when they're small the plant will put the energy it would have put into growing that fan leaf, into growing the branch/other leaves. Sounds more like stoner logic than anything else. In fact i went in for another trim over the weekend sometime and again cut looooads of leaves off. Some i think i shudnt've cut as branching hadn't started properly at some nodes, and now i dont know if these nodes will produce branches anymore. Gona give the whole plant a spray with a product called "Halo" - hopefully it'll kickstart new branches and foliage.
Disadvantages: More leaves means the plant can produce more energy, also stores energy in fan leaves. Cutting them off probably also slows growth a little due to minor stresses.
Generally i'd say not to cut off fan leaves unless u have a good reason to, i.e its shading bud sites lower down and preventing them from growing, or if its a dying leaf. Cutting off fan leaves can be done at any time throughout the grow, i usually inspect and trim when-ever and where-ever i see fit. Just dont go cutting them all off and u should be fine.
that would be fucking awsome to scrog into shapes i bet u could totally do that lol
I've only ever seen flat Scrogs and U-shaped scrogs, i'm thinking a Geodesic Dome for my next project though, would need to build a purpose built setup though, this cab definitely wont do. If only i could do this all legally and dedicate a whole room to it... I'd have loooads of little experiments going on.
looking really nice man, youre doing a good job with the training but im wondering will the kennex be strong enough to keep it down once it gets bigger? lets hope so
Cheers, you'll see the advantages of a K'nex screen in my next update, turned the plant around 90 degrees and re-shaped the screen, kinda hard to explain. Anyway its already started to pull the screen up! i've had to tie the screen down to the bucket