cloning in bubbles?

med4u

med4u

Well-Known Member
just started dwc/bubble and was wondering if i can simply put clone stems in the water or should they be above water line? thanx for any advice
 
M

Montag

Member
There is a bubble cloner DIY around somewhere where the guy states to place the clones about 1/4" from the bubbling water. I don't know what air pump or air stones he used, but the water looked like it was at a rolling boil.
 
BloodHoundsRule

BloodHoundsRule

Well-Known Member
med4u said:
just started dwc/bubble and was wondering if i can simply put clone stems in the water or should they be above water line? thanx for any advice
Click to expand...
About a 1/4" to a 1/2" above the water. That works great in my Bubble Cloner. The stems on your clones should always be wet when you check them. If not move them down closer to the water and check again.
 
RawBudzski

RawBudzski

Well-Known Member
just made my Bubble cloner today. looks great ! i put 1/2 above water 1/2 below. im sure it wont matter. i have a great air pump
 
MRHOOD

MRHOOD

Member
After roots form from the clone, what is the next step. I have all the pieces to make a bubble cloner I'm just not understanding what to do with the clone after roots are formed.
 
RawBudzski

RawBudzski

Well-Known Member
When you have a good few inches of roots... Put in the medium of your choice. if soil. Be VERY CAREFUL, cover with soil. make sturdy. WATER HEAVILY. Then let it dry out almost COMPLETELY before next watering so the roots begin to LOOK for water.
 
You must log in or register to reply here.
Top